Unit will automatically stop once the dryer door is opened. The start button must be once again pushed to resume operation once the door is closed. 6 GDZ22-1 manual 10/22/01 11:45 AM Page 8 English Other Features Your dryer also has the following features for your convenience: Dry Sensor: (feature only active in auto dry cycle) • This senses the dampness in the clothes. The dryer will automatically shut itself off once it senses that the clothes are dry. End of Cycle Signal: • Your dryer is equi

Fabric Care Labels Below are fabric care label “symbols” that affect the clothing you will be laundering. WASH LABELS DRYLABELS Operating Instructions The Exterior: Wipe or dust any spills or washing compounds with a damp cloth. Dryer control panel and finishes may be damaged by some laundry pretreatment soil and stain remover products. Apply these products away from the dryer. The fabric may then be washed and dried normally. Damage to your dryer caused by these products is not covered by your

12. The interior of the dryer and exhaust duct should be cleaned periodically by qualified service personnel. 13. This appliance must be properly grounded. Never plug the appliance cord into a receptacle which is not grounded adequately and in accordance with local and national codes. See installation instructions for grounding this appliance. 14. Do not sit on top of the clothes dryer. Important Safety Notice & Warning The California Safe Drinking Water and Toxic Enforcement Act of 1986 (Propos

Service or performance problems caused by use of these products are the responsibility of the manufacturers of those products and are not covered under the warranty to this appliance. ¦ Before discarding a dryer, or removing it from service, remove the dryer door to prevent children from hiding inside. ¦ Do not tamper with controls. Customer ServiceTroubleshooting TipsOperating InstructionsSafety Instructions Read and follow this Safety Information carefully. SAVE THESE INSTRUCTIONS 5 Operating

Finger tighten the nut only at this time. 3. Remove the green neutral ground wire from the green ground screw located above the terminal block. Typical Conductor Receptacle y Black 240V '-White Neutral Typical 4 ■ Conductor Cord V^v-Red 240V \ Green Ground 16 English 4. Thread a U.L. approved 30 Amp power cord. NEMA 14-30 type ST or SRDT through the strain relief. 5. Attach the green power cord ground wire to the cabinet with green ground screw. 6. Attach the green wire conductors fr

Excessive lint can build up inside exhaust system and create a fire hazard and restrict air flow. Restricted air flow will increase drying time. If your present system is made up of plastic duct or metal foil duct, replace it with a rigid or flexible metal duct. Ensure present duct is free of any lint prior to installing dryer duct. 2. The dryer must not be exhausted into any gas vent, chimney, wall, ceiling or any concealed space of a building. The dryer exhaust system MUST be exhausted to the

Troubleshooting Symptom Possible Cause Solution Unit has slight odor during operation. Heating element can have odor on initial operation. None required - Odor will quickly disappear. Unit won’t operate on “heat” or “no heat” setting”. ALCI plug may be tripped. Press reset button. Plug-in again - If button pops again DO NOT USE PRODUCT. Unit works but then shuts off. Dryer is equipped with overheat protector. If the internal temperature reaches 75.C (167°F) the dryer will automatically turn itse

Align the drawer supports to the slides on each side. Reinstall the original screws into each drawer slide. Tighten both screws. Open the drawer fully. Slide drawer divider into slots in the center of the drawer. The drawer should slide smoothly when you push it closed. D C B A 5 Drawer divider REMOVE SHIPPING SCREWS Remove the 4 shipping screws on the back side of the unit. 6 FINALIZE THE INSTALLATION Refer to the washer or dryer Installation Instructions to complete the installation. 7 SPECIFI

• See washer and dryer installation instructions for additional installation requirements and guidelines. 2 Installation Instructions INSTALL THE PEDESTAL TO THE WASHER OR DRYER Place the pedestal against the bottom of the unit. Check to be sure the drawer front is at the front of the unit. Align the holes in the pedestal with the holes in the bottom of the unit. Use a Phillips screwdriver to install the 4 screws through the pedestal and into the unit—do not tighten. Slide the pedestal toward th