Log:
Téléchargements : 19   Taille : 227 kb   Fabricant : Amana  
Catégorie : Séchoirs
@name

Use the foam-removing spin- ning to remove the extra deter- gent liquid. It can both shorten the washing time and save the water consumption. Please put in the gland properly even if the laundries .Do not leave any articles above the depression cover. Push Gland Push Proper The laundries are slanting Proper No gland In spinning, it will pause the work if you open the outer cover of the spintub. Close it to resume the spinning. quantity is small. Maintenance 1 2 Wipe off the water drops on the su

Téléchargements : 20   Taille : 1 mb   Fabricant : Amana  
Catégorie : Séchoirs
@name

Do not use harsh or abrasive cleaners, this could damage the dryer. Clean the duct and the vent on a regular basis to avoid clogging which could affect the efficiency of the dryer. English Troubleshooting Dryer does not operate: Check if unit is plugged in. The plug may have come loose. Check if the electrical wall socket is the correct voltage. Check if the circuit breaker needs to be reset or if the fuse needs to be replaced. Check if the unit is in Off mode. Press Power On/Off button again. C

Téléchargements : 18   Taille : 1 mb   Fabricant : Amana  
Catégorie : Séchoirs
@name

3. Press "More Time" And "Less Time" buttons to set a suitable time After setting "Timed/Cycle" to "Timed Dry" , you can press these two buttons to increase or decrease drying time as you desires. 4-6. Press buttons "Temp", "Cycle Signal"and "Wrinkle Care" to define your desired program Notes: For "Timed Dry" program, use of buttons "Temp", "Cycle Signal", "Delay Start" and "Wrinkle Care" is the same as for auto-programs. "Sensor Dryness Level" is here inactive, pressing of which will get alarms

Téléchargements : 10   Taille : 619 kb   Fabricant : Amana  
Catégorie : Séchoirs
@name

of rigid or flexible metal. When in place, the duct must have no more than two 90 ° bends and must not exceed length listed in INSTALLATION INSTRUCTIONS. Electric dryer is connected to a 208 volt Drying time will be 20% longer than drying on a 240 volt circuit, circuit. Drying procedures have not been followed. See Drying Procedures, page 4. Outside exhaust hood or exhaust duct may Clean out any obstruction. be clogged or restricted. High humidity. Use a dehumidifier near the dryer. Excessive wr

Téléchargements : 11   Taille : 4 kb   Fabricant : Amana  
Catégorie : Séchoirs

Téléchargements : 13   Taille : 4 kb   Fabricant : Amana  
Catégorie : Séchoirs

Téléchargements : 13   Taille : 4 kb   Fabricant : Amana  
Catégorie : Séchoirs

Téléchargements : 18   Taille : 1 mb   Fabricant : Amana  
Catégorie : Séchoirs
@name@name

. . . . . . 1-2 Dryer Exhaust Tips . . . . . . . . . . . . . . . . . . . .3 Operating Tips . . . . . . . . . . . . . . . . . . . . . . .4 Using the Controls . . . . . . . . . . . . . . . . . .5-6 Special Laundry Tips . . . . . . . . . . . . . . . . . .7 Careand Cleaning . . . . . . . . . . . . . . . . . . . .8 Replace Drum Light . . . . . . . . . . . . . . . . . . . 8 Reverse the Door . . . . . . . . . . . . . . . . . . . . .8 Troubleshooting . . . . . . . . . . . . . . . . . . . . . 9 Drying Ra

Téléchargements : 14   Taille : 989 kb   Fabricant : Amana  
Catégorie : Séchoirs
@name

If the permanent press load is wrinkled, add a wet towel and operate the dryer for an additional 10 minutes with heat and cool down, remove load immediately. LINT FILTER The lint filter is located at the front of the dryer in the lower part of the door opening. See illustration below. CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. A clean lint filter insures efficient drying. The filter can be taken out to remove lint. TO REMOVE LINT: Wipe across the filter with damp fingers. TO REMOVE LIN

Téléchargements : 14   Taille : 550 kb   Fabricant : Amana  
Catégorie : Séchoirs
@name

There are two settings in the AUTOMATIC REGULAR/DELICATE cycle—MORE DRY, and LESS DRY. Time Dry Cycle This cycle will operate dryer for up to 75 minutes. Cottons and heavyweight items dry best between 50 and 75 minutes, and lightweight items dry best between 20 and 40 minutes. Automatic Permanent Press/Knits Cycle Use for permanent press items and synthetics. The type of heat is determined by selecting the proper Fabric Selector option. There are two settings in the AUTOMATIC PERMANENT PRESS





catégories