Évaluations - 3, GPA: 4.7
(
)
)
|
Facilité d'utilisation
2) Press the CH+ or CH-to select the item you want to adjust. 3) Press the VOL+ or VOL- to adjust the item. 9.Timer setting1) Press the MENU button repeatedly until the CLOCK menu appears as shown in the right. 2) Press the CH+ or CH- to select the item you want to set. 3) Press VOL+ to set hour and press VOL- to set minute. : Adjust : Select CLOCK Time : : On-time : Off-time : Attention : Exchange Position : Select : Adjust Note1: All keys mentioned above are on the remote control unless indicated otherwise.. Note2: For more detailed information, please refer to the owner's manual. -4 -5- Learning about your new TV You can operate your TV by using the buttons on the front panel or the remote control. All the terminals on the front and the back panel provide the connections you will need to connect other equipment to your TV. Caution: The TV power plug has one prong wider than the other and will fit only one way into a standard electrical outlet(120VAC,60Hz).If the plug does not fit into the outlet, try turning it around. If the plug still does not fit, the outlet is probably non-standard and must be replaced by a qualified electrician. Do not tamper with the plug or try to force it into a non-standard outlet. Selecting a location for the TV 1) Place the TV on the floor or on a sturdy platform in a location where light does not directly hit the screen. 2) Place the TV far enough from the walls to allow proper ventilation. Inadequate ventilation may cause overheating, which may damage the TV. Note: The above figures are for reference only, please refer to the actual units to determine their appearance. Front Controls Back Connections Aerial socket AC CORD AND PLUG S-Video Front panel Video output Audio output(left) Audio input(right) Audio output(right) Video input Audio input(left) INPUT L(MONO) R R OUTPUT VIDEO VIDEO L(MONO) AUDIO If you haven't connected electronic equipment before, or you have been frustrated in the past, you may wish to read this section.(Cables are not supplied.) Caution: Do not plug the TV in until you have finished connecting all of your equipment. Connecting your TV CHANNEL DOWN VOLUME UP MENU VOLUME DOWN TV/AV TV/AV MENU VOL CH CHANNEL UP POWER INDICATOR INFRARED SENSOR POWER SWITCH S-VIDEO RIGHT LEFT VIDEO To enjoy the programs coming from your audiovisual equipments such as VCR, DVD, Satellite receiver, Camcorder, Audio amplifier and etc, the signal must be received by the set via the AV input terminals at rear. You can also record the TV programs to a video tape by VCR. Connect the devices as the following figure. Note: 1.The program coming through AV input terminals can't be re-recorded via AV output terminals. 2.When the TV is in AV mode, there is no signal output on the OUTPUT terminals. 3.When connecting S-VIDEO, Audio Left and Right cables should be connected to AUDIO INPUT terminals. Also the S-VIDEO and VIDEO INPUT terminals can't be connected simultaneously. When you want to watch TV program, please shut the S-VIDEO signal. Connecting the audiovisual equipments Connecting your TV To enjoy the terrestrial signal transmitted by your local TV station, you need an indoor or outdoor aerial (not supplied). Perfect picture quality requires a good signal and generally means that an outdoor aerial must be implemented. The exact type and location of the aerial will depend on your particular area. Consult your local dealer or service personnel for best advice. If you are a subscriber of your local CATV net, the outdoor or indoor aerial is not needed. Connect the equipments as the following figure. -6- AERIAL SOCKET REAR VIEW TWIN-LEAD FEEDER(300¦.) Loosen the screw Insert the feeder in Tighten the screw Plug(not supplied) Adaptor (not supplied) The signal comes from: ! An outdoor aerial ! An indoor aerial Connecting the aerial To the input terminals PLAY VIDEO TAPE, DVD etc. INPUT OUTPUT VIDEO VIDEO LEFT(MONO) LEFT(MONO) RIGHT RIGHT VCR/DVD RECORD THE TV PROGRAM From the output terminals INPUT L(MONO) R R OUTPUT VIDEO VIDEO L(MONO) S-VIDEO TV AUDIO S-VIDEO COAXIAL CABLE(75¦.) Connecting your TV Connecting a cable converter box This television has an extended tuning range and can tune most cable channels without using a cable company supplied converter box. Some cable companies offer [premium pay channels] in which signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the cable company. For subscribers to Basic Cable TV Service For basic cable service not requiring a Converter/Descrambler box, connect the CATV 75 ohm Coaxial Cable directly to the Antenna Jack on the back of the television. For subscribers to Scrambled Cable TV Service If you subscribe to a cable service which requires the use of a Converter/Descrambler box, connect the incoming cable to the Converter/Descrambler box and connect the output of the box to the Antenna Jack on the back of the television. Follow the connections shown belo...
Ce manuel est également adapté pour les modèles :TV - TC14FS68 (1.16 mb)
TV - TC14FS68 (1.16 mb)