Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
BEFORE YOU OPERATE YOUR NEW TELEVISION To get the most from your new color television, read and follow this Owner's Manual carefully. INSTALLATION GUIDELINES Place your TV in a room with adequate ventilation. Keep your TV set away from sources of direct heat, such as heat registers or direct sunlight. Do not place your TV on soft surfaces, such as rugs or blankets. Leave enough room for air to circulate around the bottom, top and back of the set. ANTENNA CONNECTIONS For best picture quality, we recommend that you use an outdoor antenna. Follow in structions on page 6 for proper antenna hookup. POWER CONNECTION Your TV works on normal household current (120 volts, 60 Hz). For safety purposes, your TV's electrical plug has one blade wider than the other. If you cannot insert the plug fully into the socket, try reversing it. In the space provided, record the serial and model numbers, located on the rear of the unit. Serial No. Model No. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with the arrowhead symbol within an The exclamation point within an equilateral triangle is equilateral triangle, is intended to alert the user to the intended to alert the user to the presence of important presence of uninsulated "dangerous voltage" within the operating and maintenance (servicing) instructions in product's enclosure that may be of sufficient magnitude the literature accompanying the appliance. to constitute a risk of electric shock to someone. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. – 1 – FEATURES On-screen graphics guide you through setup features and operations Automatic programming of channels allows easy selection of stations available in your viewing area Sleep timer programs the TV to turn itself off at a preset time One day timer programs the TV to come on once at a preset time Weekly timer programs the TV to come on at a preset time every day 26-button infrared remote control allows remote operation VHF/UHF/CATV tuning allows reception of standard broadcasts or cable TV channels Close caption decoder displays captions or half-screen text V-Block function SPECIFICATIONS AC Power Input: 120V, 60Hz AC Power Consumption: 98Watts Chassis Construction: IC Solid State Picture Tube: 19" (measured diagonally) Speaker: 3.5 x 2 in. (90 x 50 mm) Oval, 8 ohms Tuner: 181 Channel, Freq. Synthesized Remote Control: Infrared, Direct Access 26 Key, 2 "AA" batteries Receiving Channels: VHF 2–13 UHF 14–69 CATV Mid Band 14–22 Super Band 23–36 Hyper Band 37–65 Ultra Band 66–94, 100–125 Sub Mid Band 1, 95–99 Cabinet: Monitor Style Antenna Input Impedance: 75 ohm (VHF/UHF) Coaxial Input CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. – 2 – LOCATION OF CONTROLS (Rectangle comment Hashimah 25.09.2000 12:41:02 blank) 1235678 4 9 POWER SWITCH CHANNEL (UP) BUTTON CHANNEL (DOWN) BUTTON VOLUME (UP) BUTTON VOLUME (DOWN) BUTTON REMOTE CONTROL SENSOR AUDIO IN (PUT) JACK VIDEO IN (PUT) JACK VHF / UHF EXT. ANT. JACK (REAR OF SET) -3 REMOTE CONTROL REMOTE CONTROL ANTENNA CONNECTIONS If you are using an indoor or outdoor antenna (antennas no t included) follow the instructions below that correspond to your antenna system. If you are using a cable IIItelevision service (CATV), refer to CATV connections. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire) 75 ohm Connect the 75 ohm cable from combination VHF/UHF antenna to the antenna jack. OR If your combination antenna has a 300 ohm twin-lead wire, use the 300-75 ohm matching transformer (not included) CATV CONNECTIONS NOTES To prevent problems it is recommended that you use only the specified trans- former. (Transformer Part No.:1398-017) ANT Transformer (not included) OR 300 Ohm ANT For subscribers to basic cable service. For basic cable service without a converter/descrambler box, connect the CATV 75 ohm coaxial cable directly to the antenna jack on back of the unit. – 6 – Some cable companies offer "premium pay" channels in which the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the cable company. The illustrations below show how to connect these types of converter/descrambler devices with the TV's VHF antenna jack. You may need a two-set signal splitter (sometime called a "two-set coupler) and an A/B switch box from the cable installer or an electronic supply store. With the A/B switch in the "B" position, you can then tune directly to any non-scrambled channels using your TV's tuning system or remote control. In the "A" position, you can tune your TV to the output channel of the decoder (generally Channel 3/4) and use the cable company's equipment to tune scrambled channels. Since cable systems v...