Évaluations - 5, GPA: 4.4
(
)
)
|
Facilité d'utilisation
Shake off any dust from the cloth before use. Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off. Do not dunk the 3D Eyewear in liquid such as water when cleaning. Avoid storing the 3D Eyewear in hot or highly humid locations. NOTE • As the liquid crystal shutters (lens) are fragile and easily broken, be very careful when cleaning them. ENGLISH - 9 Disposal A lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations. When disposing this product, disassemble properly by following the procedure on the next page, and remove the internal rechargeable battery. Do not disassemble this product except when disposing of it. Danger ..As the rechargeable battery is specifically for this product, do notuse it for any other device. Do not charge the removed battery. Do not throw the battery in a fire, or apply heat to it. Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it. Do not let the wires touch any other metal or each other. Do not carry or store the battery with a necklace, hair pin, or the like. Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun. Doing so may cause the battery to generate heat, ignite, or rupture. Warning ..Do not place the removed battery, screws, and other items withinreach of infants. Accidental swallowing of such an item may have an adverse effect on the body. In the event that you think such an item has been swallowed, consult a doctor immediately. ..In the event of fluid leaking from the battery, take the followingmeasure, and do not touch the fluid with bare hands. Fluid entering into an eye may cause loss of eyesight. Wash the eye with water immediately without rubbing it, and then consult a doctor. Fluid getting on your body or clothes may cause inflammation of the skin or injury. Sufficiently rinse with clean water, and then consult a doctor. 10 - ENGLISH ..How to remove the battery Disassemble this product after the battery has run out of power. The following figures are intended to explain how to dispose of the product, not for describing how to repair. The product cannot be repaired once it has been disassembled. 1. Fold the part of the frame without the power switch, and then remove the two screws on the inside of the hinge with a precision Phillips (plus ) screwdriver. Screws Frame 2. Bend the frame inwards and pull it off Side cover from the side cover. If it is difficult to remove, insert a flat-blade (minus ) screwdriver and force it off. Battery 3. Remove the battery from inside the side cover, and cut the two wires one by one with scissors. Insulate the wire parts of the removed battery with cellophane tape. NOTE • Take sufficient care when performing this work so as not to injure yourself. • Do not damage or dismantle the battery. ENGLISH - 11 Troubleshooting/Q&A Check the followings first. If they do not solve the problem, please contact the place of purchase. ..Images are not 3D. Are the image settings switched to 3D images? Some 3D image signals are not automatically recognized as 3D images. Set “3D Eyewear” to “On”. For details, see the television operating instructions. Is there a sticker or other such item blocking the infra-red reception section onthe 3D Eyewear? If the eyewear stops receiving infra-red signal from the television, the powerautomatically switches off after 5 minutes. Check that there are no objects blocking the path between the television and3D Eyewear. Individual differences may occur in which the 3D images are difficult to see, or cannot be seen, especially in users that have a different level of eyesightbetween the left and right eyes. Take the necessary steps (wearing glasses etc.) to correct your eyesight before use. ..The power of the 3D Eyewear turns off by itself. Are there any objects between the eyewear and television? Is there a sticker or other such item blocking the infra-red reception section onthe 3D Eyewear? If the eyewear stops receiving infra-red signal from the television, the powerautomatically switches off after 5 minutes. Check that there are no objects blocking the path between the television and3D Eyewear. ..There is something wrong with the 3D images. Are the left and right sides of the 3D image reversed? Switch the left and right sides of the 3D image. For details, see the television operating instructions. ..The indicator lamp does not light when the power switch is setto “ON”. The battery is too low to operate the 3D Eyewear. The battery is completely flat if the indicator lamp does not light when the powerswitch is set to “ON”. Charge the battery. ..The battery does not charge, or operation time is short whencharged. Is the charging cable connected properly? Check the connection. Is the television power off? Turn the television power on, and charge the battery. The battery has reached the end of its lifespan. If operation time is ve...