Évaluations - , GPA: ( )

Instructions Toshiba, Modèle 32HL66

Fabricant : Toshiba
Taille : 1.97 mb
Nom Fichier :

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

To program your TV remote control to operate a non-Toshiba device (or a Toshiba device that it is not preprogrammed to operate), follow the steps below. For details on using the remote control to operate the device, see page 9. 1 In the remote control code table (- page 12), find the code for your device. If more than one code is listed, try each one separately until you find one that works. 2 Set the MODE SELECT switch to the type of device you are programming the remote control to operate — CABLE/SAT (for a cable converter box or satellite receiver), DVD (for a DVD player or HTIB [home theater in a box]), or VCR (for a VCR or TV/VCR combo). 3 While holding down E, press the Channel Number buttons to enter the 3-digit code for your device. 4 To test the code, turn on the device, point the remote control at it, and press p. See notes below. • If the correct code was entered, the device will turn off. • If the device does not respond, repeat steps 1–4 using another code. • If the device does not respond to another code, you will need to use the remote control that came with the device. 5 Remember to set the MODE SELECT switch back to “TV” to control the TV. 6 For future reference, write down the code(s) you used: DEVICE CODE DEVICE CODE Note: • In addition to POWER, confirm that all necessary keys on the TV remote control operate your device. If some keys are not operational, repeat the device code setup using another code (if other codes are listed for your device). If, after trying all listed codes, the necessary keys do not operate your device, use the device’s original remote control. • Every time you change the batteries, you will need to reprogram the remote control. • Some newer VCRs respond to either of two codes. These VCRs have a switch labeled “VCR1/VCR2.” If your VCR has this kind of switch and does not respond to the codes for your VCR brand, set the switch to the other position (“VCR1” or “VCR2”) and reprogram the remote control. Chapter 2: Using the remote control Remote control codes In some cases you may not be able to operate your device with the TV remote control. Your other device may use a code that is not recognized by the TV remote control. If this happens, use the device’s remote control. Cable converter box ABC 061,...