Log:
Évaluations - 3, GPA: 4.3 ( )

Instructions Omnimount, Modèle 10.0 W/C

Fabricant : Omnimount
Taille : 272.81 kb
Nom Fichier : b91882a3-e899-4384-a00d-38c2e5ae19d5.pdf
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


CLAMP ASSEMBLY ORIENTATION A) Wall Mount A) Ceiling Mount C) Drywall Mounting Use W" drill bit Irvseit anchor into hole “Pop" ball into the clamp assembly. Set speaker to desired position. Tighten clamp assembly until snug. Note: Speaker weight must be lully supported during the tightening process. OMNI 10.0 SPEAKER MOUNT USER’S GUIDE REQUIREO TOOLS A. 5/32' hex wrench (supplied) Drill bits: B. Wood 5/32' C. Dr/Mail - W" 0. Masonry - VI6" carbide tipped E Crescent or 7/16* (11mm) open end »tench F. Phillips screwdriver G. Electric drill H. Hammer (masonry only) 1. SPEAKER OPTIONS A) /4" 20 Threaded Insert C) Mounting Plate 3. MOUNTING THE CLAMP ASSEMBLY A) Mark Location Mark mounting holes with pencil B) Mounting onto Wooden Stud. Use 5/32" drill bit Minimum mounting hole depth: 2" (51mm) E) Mount Clamp Assembly Attach clamp assembly with supplied screws. 5. FINAL ADJUSTMENTS Use tool to tighten in 1/2 turn increments. Do not over tighten. To change speaker angle, loosen tension screw, re position speaker, then re-tighten tension screw. To rotate speaker cabinet loosen jam nut. rotate speaker into desired position, then re-tighten jam nut D) Mounting into Masonry 5/16” (8mm) carbide tipped bit and masonry or hammer drill. Wear eye protection Minimum mounting hole depth: 2" (51mm) Insert anchor into hole Minting Surf*?« PART* III 4. JOINING BALL SHAFT AND CLAMP ASSEMBLY Open clamp assembly enough to accept ball....


Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories