Nor this document, nor any part of it, may be reproduced or copied in any form or by any means - graphical, electronic, or mechanical including photocopying, taping or information storage and retrieval systems - without written permission of Barco © 2010 Barco N.V. All rights reserved. Table of Contents Table of Contents Preface ................................................................................................. 5 Environmental information............................................

3. Push the cursor key ^ or v to highlight x-white. 4. Press ENTER to select. A bar scale will be displayed. 5. Press the ^ or v to change the x-white value. Adjust until the desired value is almost reached. Release the button and wait a few seconds. The color of the image will be adapted. Fine tune with the ^ or v keys until the correct value is reached. 6. Press EXIT to return to the Custom balance menu. 7. Repeat from step 3 by highlighting y-white and adjust in the same way. Image settings C

Press ADJ or ENTER to start up the Main menu. (menu 9-1) 2. Push the cursor key ^ or v to select Installation. 3. Press ENTER to select. The Installation menu will be displayed. (menu 9-2) Main Menu Image settings Advanced settings Installation Service 1. PC 2. RGB/Component 3. DVI 4. SVideo * 5. Video 6. Component Shutdown Back Menu9-1 Input Slots Installation Input slots File service Internal pattern When no signal Source transition OSD configuration Language V-Keystone H-Keystone Global keyst

: R5975348 R9001280 OWNER'S MANUAL VISION 8200 Rev : 01 BARCO PROJECTION SYSTEMS Date : 280497 Art. No. : R5975348 R9001280 OWNER'S MANUAL VISION 8200 Rev : 01 Due to constant research, the information in this manual is subject to change without notice. Produced by BARCO NV, April 1997. All rights reserved. Trademarks are the rights of their respective owners. Printed in Belgium BARCO nv/Projection Systems Noordlaan 5 B-8520 Kuurne Belgium Printed in Belgium Table of Contents TABLE OF CONTENTS i

The switching between the 2 modes can only be done 6 times and this only during the first 100 hours of the lamp lifetime (considering a dual lamp mode i.e. both lamps are used). Lamps replacement 1000Runtime (hours) Power Mode Switching 1500 (Full power mode) Power Mode Switching possible (max 6 times ! ) possible (max 6 times ! ) or 3000 (econmy mode) Image 10-5 Lamp power mode (projector considered to be running in dual lamp mode i.e. with both lamps on) Above considerations and numbers (lifet