Évaluations - 3, GPA: 4 ( )

Fabricant : Aube Technologies Taille : 455.71 kb Nom Fichier : Langue d'enseignement:

¦ The installation is now complete. Continue reading Owner’s Manual for complete operating instructions. HEAT OFF COOL AUTO FAN RESET FIGURE 5 WRC RH YG RH RH FIGURE 3 FIGURE 4 Programming 16-17 When you first install in the installation the Reset Button. Start-Up 16-17 When you first install in the installation the Reset Button. Start-Up n The thermostat is preset at the factory to 68°F (n Room temperature is displayed. ¦ Your thermostat batteries will prevent memory loss and avoid reprogramming. Replace batteries as soon as low battery indicator ¦ A built-in timer prevents damage to your air conditioner caused by rapid cycling, by providing a delay of 4 minutes before it will restart. n The thermostat will display room temperature from 32°F to 99°F. (0°C to 37°C). n The temperature can be set from 40°F to 95°F. (5°C to 35°C). Reviewing Current Temperature Setting n 69° is current room temperature. TEMP 69 Press For 2 n 68° indicates the current setting Seconds Or SET TEMP 68 or of the thermostat. Less ¦ If pressed for more than 2 seconds, you will adjust the setting as explained below. Setting In this example raising the current set temperature of 68°F to a new Press n Press arrow to display current And SET TEMP 68 temperature setting. Hold 68°F is the current temperature setting. ¦ After 3 seconds, “SET” starts flashing and temperature digits SET TEMP will increase. 72 ¦ Release at 72°F. ¦ The display returns to current TEMP room temperature in 5 seconds. ¦ “HEAT” will appear indicating 69 heat has turned on. HEAT Operations 18-19 72.7I. 70. Filter Monitor The Hunter Digital Thermostat and stores the amount of time conditioning system operated. After 500 hours of usage, the “FILTER” will appear and flash on reminding you to check or replace your system filter. TEMP FILTER 69 The word “FILTER” will continue flashing until the filter counter is reset back to zero. TEMP FILTER 69 To Reset Zero 69 69 TEMP n After 5 seconds, counter is reset, the “FILTER” Press FILTER disappears from the display. Note: Filter button works only when is displayed on the display. If Filter button is pressed when “FILTER” is not displayed, the internal counter will not reset. Temperature Span Your thermostat is pre-programmed at the 1° above or 1° below the temperature factory to cycle when the temperature rises setting. It cannot be changed. Backlighting (Model 44050 only) Press LIGHT The display will remain backlit for approximately five (5) seconds. If another Your thermostat comes with an electrolumi- button is pushed, the five second timer will nescent lamp for easy viewing of the display reset, and the light will turn off five seconds in the dark. To activate press the “light” after the last button is pressed. button between the up and down arrow keys. Troubleshooting Problem Solution 20-21 SCRAMBLED OR DOUBLE (numbers over numbers 1. Remove clear mylar NO DISPLAY 1. Check battery connections and 2. Press reset button once with a small pin and hold in for two sec...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :