Évaluations - 4, GPA: 4
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
The hour value will blink. (D Press the Adjust button to set the correct hour. Set the minute. * © Press the Set button. The minute value will blink. (2) Press the Adjust button repeatedly to set the correct minute. Press the Set button at the exact time the minute changes to finalize the date/time setting. Press the On/Off Start button to switch off the power. 6 7 When the date or time are blinking, the clock is stopped. During leap years, 3/1 will be displayed on February 29. For this reason, reset the date to 2/29. Use the tip of a ballpoint pen or similar object to lightly press the Set and Adjust buttons. If you use a mechanical pencil, the lead may break, causing a malfunction. 12 Getting into the measurement position Either the left or right arm can be measured. However, when measurements are taken using the right arm, it may be difficult to see the display. * Since there may be blood pressure differences of around 10mmHg between the left and right arm, be sure to use the same arm Ibr all measurements. * The product cannot be used while lying down. Please sit upright during use. Place the main unit on a table or similar object so that the main unit is at the same height as your heart. * Differences in height will cause differences in blood pressure values. If the heights of the chair and table are not suitable, you may have to lean forward. In this case, form a stable stack of books or similar objects under the main unit to adjust the height of the main unit. 1 Sit next to the table as shown in the figure at left. Elbow support Slide your arm through the measuring section. Pull the main unit close to you so that you do not have to lean to reach it. • Remove your shirt or roll up your sleeve so that the measuring section will be on your bare skin. • If rolling up your sleeve causes pressure on your arm or underarm, remove your shirt for measurements. Be sure that the rolled-up sleeve does not get inside the measuring section when taking measurements. Place youreibow in the support • If it is difficult to find the elbow support, use your other hand to locate it. Stretch out your arm and sit straight. • The unit will naturally pivot upwards up to 15” a you place your hand on the table in a relaxed position. 13 CAUTIONS DURING MEASUREMENTS In the following situations, accurate measurements cannot be taken. OWithin 1 hour of eating or drinking alcohol Olmmediately after drinking coffee or tea, or smoking Olmmediately after exercising or taking a bath -Wait at least 20 minutes and take a measurement while staying quiet. Oln a moving vehicle Oln cold places -Take measurements at ambient temperatures of 10°C to 40°C (50°F to 104°F). OWhen you need to urinate -Walt several minutes after urinating before taking measurements. TAKING A READING Cautions to obtain accurate measurements Sit quietly and relax while taking measurements. 14 Do not lift the main unit off the table. Keep it on the table during measurements. Do not let your rolled-up sleeve be inside the measuring section. Roll your sleeve far up your arm. Do not lift your arm. Rest your hand on the table with your palm upwards. X Be sure to obey the following points for accurate measurements: • Do not move your body, arm, or fingertips. • Do not touch the main unit. • Do not talk. • Do not use a cellular phone near the main unit. Not following these points may make it impossible to obtain accurate measurements. The angle of this product can be adjusted so that measurements can be taken without having to be in a forced posture. • The angle can be adjusted only when the display Is open • The angle is not locked. Even if you sit still, the angle may change slightly during pressurization. However, there is no effect on accuracy even if the angle changes during measurements. 15 TAKING A READING (CONTINUED) Measurement 1 PrGSS the On/Off Start button. ® The pressure cuff will be tightened automatically. © Pressurization will be performed automatically and measurements will be taken. PPP ODD POP GOO Vi OO E7I _ lUU CDo'fa'CDb'S ► ► The entire display will light for approximately 1 second. IU3 113 ptpf o c rri u_ CD CD The pressure cuff will be tightened automatically. The heart mark V will blink when pulse is detected during pressurization. When measurement has been completed, the blood pressure and pulse values will be displayed. After measurement values have been shown for approximately 5 seconds, the pressure cuff will be loose. (However, the time depends on the size of the arm.) • The blood pressure indicator lamps will light (for approximately 12 seconds). • If the measured value is in the high blood pressure region, the values will blink (for approximately 12 seconds). (For how to read the blood pressure display, see p. 17.) • The (X) CE) mate will light (For storing measurement values, see p. 19.) • The pulse rate value is the beats per minute calculated...