Évaluations - 3, GPA: 3
(
)
)
|
Facilité d'utilisation
EACH PROGRAM HAS 10 SEGMENTS. THE LENGTH OF TIME FOR EACH SEGMENT IS BASED ON THE TIME LENGTH OF THE PROGRAM. IF YOU SET THE PROGRAM TO 30 MINUTES, EACH SEGMENT IS 3 MINUTES LONG (TIME divided by 10 segments). YOU CAN ALSO CUSTOMIZE THE TIME, SPEED, AND INCLINE FOR EACH OF THESE PROGRAMS. SEE PAGE 12 FOR PROGRAMMING THE P1 AND P2 MODES. The WARM UP program is designed to gradually increase treadmill speed and incline (warm up) in the first segment to the set maximum speed and incline. At the end of the program, the treadmill will gradually decrease speed and incline to half of the maximum set (cool down) in segments 9-10. 14 Belt Adjustment and Tension WARNING! Do not overtighten rollers! This will cause premature roller bearing failure! Belt adjustment and tension performs two functions: adjustment for tension and centering. Your new treadmill comes pre-adjusted from the factory for tension and centering. Please follow the procedures below if the belt shifts left or right or if the belt slips while walking: WALKING BELT HAS SHIFTING TO THE LEFT (Diagram 1) First, unplug the power cord from the surge protector. Using the hex key provided, turn the left rear roller adjustment bolt . turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer to below to the “Walking Belt Slipping” instructions. WALKING BELT HAS SHIFTING TO THE RIGHT (Diagram 2) First, unplug the power cord from the surge protector. Using the hex key provided, turn the right rear roller adjustment bolt . turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer to below to the “Walking Belt Slipping” instructions. WALKING BELT IS SLIPPING DURING USE (Diagram 3) First, unplug the power cord from the surge protector. Using the hex key provided, turn both left and right rear roller adjustment bolts the same distance, usually a . turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should now walk on the belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not slipping. The tension should be just tight enough not to slip. 15 Maintenance Instructions WARNING! Before performing any maintenance to your treadmill, always unplug the power cord from the surge protector. CLEANING Routine cleanin...
Ce manuel est également adapté pour les modèles :Formateurs - 815 (825.87 kb)
Formateurs - 835HR (825.87 kb)
Formateurs - 815 (825.87 kb)
Formateurs - 815 (825.87 kb)