Évaluations - , GPA: ( )

Instructions Reebok Fitness, Modèle 831.288263

Fabricant : Reebok Fitness
Taille : 383.17 kb
Nom Fichier : 9627fe4a-d2db-4d77-bc81-7decb24dfc3a.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

TimeN Displays the elapsed time. Note: Time will be counted only while you are pedaling. If you stop pedaling for ten seconds or longer, the time mode will pause until you resume. DistanceNDisplays the total distance you have pedaled, in miles. CalorieNDisplays the total number of Calories you have burned. ScanNDisplays the speed, time, distance and calorie modes in a repeating cycle. Note: The electronic monitor requires two "AA" batteries (not included). See assembly step 3 on page 4 for battery installation instructions. 7 Follow the steps below to use the electronic monitor: modes will all be displayed, for five seconds each, in a repeating cycle. A second mode indicator will 1. To turn on the power, press the on/off button or show which mode is currently displayed. simply begin pedaling. B. Speed, time, distance or calorieNTo stop the 2. Select one of the five modes: scan mode and select the speed, time, distance or calorie mode for continuous display, repeatedly A. ScanN When the power is turned on, the scan mode will be selected automatically. A mode indicator will appear by Mode indicators the word "SCAN." The speed, time, distance and calorie press the mode button. Make sure that there is not a mode indicator by the word OSCAN.O The modes will be selected in the following order: speed, time, distance, calorie, scan. 3. To reset the display, turn the power off and then on again by pressing the on/off button twice. 4. When you are finished exercising, press the on/off button to turn off the power. Note: If the pedals are not moved and the buttons are not pressed for four minutes, the power will turn off automatically in order to conserve the batteries. TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts of the exercise cycle regularly. To clean the exercise cycle, use a damp cloth and mild detergent. Never use abrasives or solvents; keep liquid away from the console. ELECTRONIC MONITOR If the electronic monitor does not function properly, the batteries should be replaced. Most problems are the result of drained batteries. See assembly step 3 on page 4 for battery installation instructions. If the electronic monitor still does not function properly, the sensor wire should be checked. See assembly step 3 on page 4. Slide the electronic monitor off the frame and make sure that the sensor wire is plugged fully into the wire on the electronic monitor. TIGHTENING THE PEDALS If the pedals become loose, tighten the pedal shafts into the arms of the crank. Tighten the 1/2O Locknuts onto the pedal shafts (see assembly step 7 on page 6). ADJUSTING THE CHAIN The exercise cycle features a precision chain that must be kept properly lubricated and adjusted. Apply a few drops of light multi-purpose oil to the chain every three months. If the chain is too tight, the bearings may be damaged; if the chain is too loose, the fan may be damaged. If the chain causes excessive noise or slips as you pedal, check the chain in the following way: 1. Carefu...