Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
.. Screw propane cylinder into lantern. Take care not to cross-thread. Hand tighten only. (Fig. 9) Fig. 9 Fig. 2 Globe Ventilator Bail Upper Carrying Case AAA Battery .. Assemble bail as shown with handle toward back of the lantern. (Fig. 4) Fig. 4 Fig. 5 Fig. 6 Upper Carry Case Collar Fig. 1 .. Install upper carry case. Align the unlock symbol “ “ on the collar with the unlock symbol on the upper carry case. Rotate the upper carry case until the lock symbol “ “ on the collar aligns with the lock symbol on the upper carry case (Fig. 6). .. Install lower carry case. Align the dot symbol “ “ located on the bottom of the upper carry case with the dot symbol “ “ on the lower carry case. (Fig. 10) Fig. 10 Lower Carry Case Upper Carry Case English-4 .. Always unfold feet on lower carry case before use. (Fig. 12) Fig. 12 Fig. 11 .. Slide the carry cases together and rotate until the dot symbol “ “ on the upper carry case aligns with the lock symbol “ “. (Fig. 11) To Install Mantles Fig. 13 Fig. 14 .. Move Release Lever to the left until the lever is above the QuickLift™ unlock symbol “ “. (Fig. 13) .. Carefully remove the lantern head from the base. (Fig. 14) Release Lever .. Light bottom of mantle evenly. Burn until nothing but white ash remains. Once the mantle has been burned, it is very fragile. Be careful not to touch it with finger or match. (Fig. 18) .. Always use genuine Coleman® #95 size mantles. If using Insta-Clip® II tabbed mantles, follow the instructions on the mantle package. .. If using original wire clip mantles, attach MANTLE to BURNER TUBE AND LOWER MANTLE SUPPORT. (Fig. 15) Keep red stripe vertical and be sure clips engage grooves. Fig. 16 Fig. 17 Fig. 15 Lower Mantle Support Burner Tube Fig. 18 Fig. 19 Fig. 20 .. Replace lantern head, keeping bail toward rear of lantern. (Fig. 19) .. Move Release Lever to the right until the lever is above the QuickLift™ lock symbol “ “. (Fig. 20) Release Lever .. Twist clips. (Fig. 16 and 17) Match Light Lantern .. Push lighted match through lighting hole, hold near mantle and open fuel valve fully. (Fig. 22) Battery INSTASTART™ Electronic Ignition Lantern .. Push ignitor button and hold; then turn fuel valve on. (Fig. 21) CAUTION • SERVICE SAFETY • Keep all connections and fittings clean. Inspect propane cylinder and lantern propane connections for damage before attaching. • During set up, check all connections and fittings for leaks using soapy water. Bubbles indicate a leak. Never use a flame. Fig. 22 Fig. 21 WARNING • BURN HAZARD • Never leave lantern unattended when hot or in use. • Keep out of reach of children. NOTE: If lantern does not light, repeat above step after turning fuel valve completely off. If the lantern is wet due to rain, high humidity, etc., the ignitor may not spark. Use match lighting procedure as follows. .. Brightness may be adjusted with fuel valve. (Fig. 23) Fig. 23 To Turn Off .. Make sure lantern is cool. .. Move lantern away from flame (including pilot lights) and other ignition sources. .. Fold feet on lower carry case. (Fig. 26) .. Turn fuel valve off. (Fig. 25) To Store Fig. 25 To Light WARNING If you smell gas: 1. Do not attempt to light appliance. 2. Extinguish any open flame. 3. Disconnect from fuel supply. 4. Call 1-800-835-3278. WARNING • Replace any mantle with a hole in it. A hole can cause lantern to overheat and create a hazard. Never operate lantern without heat shield. Fig. 26 Fig. 27 .. Unlock the lower carry case and remove from the upper carry case. (Fig. 27) Fig. 24 .. The lantern may be carried by the handle. (Fig. 24) English-5 English-6 .. Place the lantern inside the lower carry case and place the upper carry case over the lantern. (Fig. 30) .. Rotate the upper carry case as shown to the lock position. (Fig. 31) .. Remove propane cylinder from lantern. (Fig. 28) .. Replace protective cap on propane cylinder. Fig. 28 Fig. 29 Upper Carry Case Collar .. Unlock the upper carry case and remove from the collar. (Fig. 29) Fig. 30 Fig. 31 Fig. 32 .. The lantern may be carried by the handle. (Fig. 32) DANGER DANGER Warranty • EXPLOSION - FIRE HAZARD • Never store propane near high heat, open flames, pilot lights, direct sunlight, other ignition sources or where temperatures exceed 120 degrees F (49°C). • The cylinder must be disconnected when the lantern is in storage. Things You Should Know 1. It is unsafe and illegal in some places to store or use liquid propane cylinders of greater than 1.14 kg (2.5 lbs.) water capacity (approximately 465g [1 lb.] propane) in occupied enclosures. 2. Always have a spare set of Coleman® Mantles. Once burned, a mantle is fragile and can be damaged if touched or dropped. 3. Wipe lantern clean with soft cloth and mild dish detergent. Do not use abrasives. 4. The usual storage areas for camping and picnic equipment are the basement, attic, or garage. To avoid the accumulation of dust, cobwebs, etc., that is common in these storage areas, place your lantern in a plastic bag and seal it ...