A 75270 rev2 22/4/08 10:40 Page 5 6 HOW TO USE 1 Ensure the blanket is fitted to the bed correctly, see diagram A. 2 Plug the power lead into the closest socket, using an extension lead, if needed, to ensure that the lead is not stretched. Preheating the bed Move the heat setting on the control switch to heat level 2 or 3, depending on the level of the heat required. Allow approximately 60-90 minutes for the blanket to heat the bed thoroughly, although this time may vary depending on the room te

. 2 Plug the power lead into the closest socket, using an extension lead, if needed, to ensure that the lead is not stretched. Start up 1 When plugged in, the red power LED will illuminate. The switch is already in time set mode. 2 Select the appropriate hour, AM/PM, by using the down arrow ‹A or the up arrow ‹B. Press the mode button fl. The minute symbol will then flash, select the appropriate time. Press mode again and the clock will be set A. Heating the bed 1 Move the slider switch to the ‘

• Do not insert pins or any sharp objects into the blanket. • Do not tuck the heated part of material under the mattress. • Do not use if the blanket is wet. • Avoid pressing creases or folds into the blanket. Do not switch on if the blanket is folded, creased or rucked. • Do not use any lead, switch or cord other than the one supplied with this blanket. • Do not coil or lay the lead on the blanket. • Not intended for medical use in hospitals. • WARNING: When storingthe appliance allow it tocool