Log:
Évaluations - 0, GPA: 0 ( )

Instructions HP, Modèle HP 4400 Dual Controller Enterprise Virtual Array w/Embedded Switch

Fabricant : HP
Taille : 380.79 kb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Par ce dispositif a également d'autres instructions :

Facilité d'utilisation









3.
Pull off the front enclosure bezel, loosen the thumbscrews on each
side that secure the enclosure to the front of the rack, and remove
Verifying component failure
the enclosure from the rack.
Check for improper or failed operation of the LEDs on the display.
Improper LED behavior may be an indication that the LED display needs
CAUTION:
to be replaced. LED indications are described in Table 1.
The controller enclosure is heavy. Two people are
Table 1 Controller status LEDs
required to remove the enclosure from the rack to
prevent injury.
LED
Description
Enclosure unit identification. Toggle pushbutton switch
with blue LED. Can be turned on or off with the
P6000 web-based operator control panel (WOCP)
or HP P6000 Command View.
Enclosure external health. Solid green indicates the
enclosure is powered on.
Enclosure fault warning. Solid amber indicates a
critical fault with an individual component.
Link to host. Solid green indicates a host connection
and amber indicates the lack of a connection.
Removing an LED display
Figure 2 Enclosure bezel removal
1.
Power down the controller enclosure with HP P6000 Command
.
View or the P6000 WOCP. Powering down the controller enclosure
4.
Remove the enclosure top access cover:
also removes power from the disk enclosures. To power down with
a.
Loosen the cover thumbscrew (1, Figure 3).
HP P6000 Command View:
b.
Slide the access panel out and off (2, Figure 3).
a.
In the navigation pane, select your storage system.
b.
In the Initialized Storage Systems Properties window, select the
Shut down tab.
c.
On the Shutdown Options pane, in the Power the Whole System
OFF section, set a value of up to 60 minutes to delay the power
down of the array (if desired). Click the Power OFF button.
2.
Remove all cables (Fibre Channel and/or SAS, Ethernet, power)
from the enclosure components. Ensure all cabling is marked so as
to facilitate reconnecting later.
Figure 3 Removing top access cover
.
Page 2

...

Ce manuel est également adapté pour les modèles :
données dispositifs de traitement - HP 4400 Dual Controller Enterprise Virtual Array (380.79 kb)
données dispositifs de traitement - HP EVA P6350 450GB 10K SAS Field Starter Kit (380.79 kb)
données dispositifs de traitement - HP EVA P6350 450GB 10K SAS FIO Starter Kit (380.79 kb)
données dispositifs de traitement - HP EVA P6350 900GB 10K SAS Field Starter Kit (380.79 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories