Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
NOTE:
After you replace the RCU card
and enable the robotics, if the RCU is
compatible with the library hardware the
MCB will load the RCU with the proper
firmware. This firmware is based on the
currently installed level of library firmware
on the MCB. If the autoleveling process
fails, the RCU becomes inoperable and the
library creates a ticket to report the issue.
If the RCU replacement is for a five to eight
frame library, and you saved the image
prior to removing the RCU, you must restore
the image using the Restore command. For
more information about the Save/Restore
commands, see the HP StoreEver Enterprise
Systems Library (ESL) G3 Tape Library User
3.
Carefully slide the RCU straight out of the LMM.
Guide.
3.
Return the library to the online state:
a.
From the View menu or in the Managed
Install the new RCU card
Views region of the OCP, click the name of
1.
Press up and out to open the latch hooks on each
the physical library.
side of the new RCU card.
b.
Click Operations→Change Mode.
2.
Align the new RCU card with the guide slots in
Alternatively, in the Managed Views section
the card slot of the LMM. The LEDs should be on
of the OCP, click the mode button next to the
the bottom of the RCU card.
name of the physical library. (The button
reads either Online or Offline.)
CAUTION:
Forcing the RCU card into the
The Change Library Mode dialog box
slot can cause the pins to bend.
appears with the current state of the physical
library shown.
3.
Apply pressure evenly to both sides of the RCU
card and slide it into the LMM until the latch hooks
c.
Select the Online button to return the physical
begin to move towards the middle of the RCU
library to an online state.
card.
4.
Push the latch hooks towards the middle of the
RCU card and into the lock position. You will feel
HP web sites
the RCU card pins connect with the LMM
backplane as it locks into place.
For additional information, see these HP web sites:
•
http://www.hp.com
•
http://www.hp.com/go/storage
Prepare the library for use
•
http://www.hp.com/service_locator
1.
Detach the ESD strap and close the service access
•
http://www.hp.com/support/manuals
door.
2.
On the OCP, press Robotics Enabled to enable
the picker assembly.
Page 3
... Ce manuel est également adapté pour les modèles :
données dispositifs de traitement - HP StoreEver ESL G3 300 slot Tape Library (240.53 kb)
données dispositifs de traitement - HP StoreEver ESL G3 700 slot Tape Library (240.53 kb)
données dispositifs de traitement - HP StoreEver ESL G3 1500 slot Tape Library (240.53 kb)
données dispositifs de traitement - HP StoreEver ESL G3 3000 slot Tape Library (240.53 kb)