Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
3.
Use one hand to completely remove the magazine
from the module while using the other hand to
support the bottom.
Verifying the magazine installation and
operation
Using the OCP or RMI:
1.
Confirm that the replaced magazine is closed.
2.
Confirm that the cartridges in the replaced
magazine are inventoried. If you replaced the
right magazine, confirm that the cartridges in the
mailslot are inventoried.
3.
If you replaced the right magazine, unlock the
mailslot using the OCP or RMI, pull it out, and
push it back in.
Getting help
•
HP Product information: www.hp.com/products/
Installing the magazine
tapestorage
1.
Position the upper and lower magazine rails onto
•
HP technical support and phone numbers:
the alignment rails.
www.hp.com/support
2.
Push in slowly until the magazine rails are
•
HP Library & Tape Tools (L&TT) diagnostic
properly seated and the magazine is only slightly
software: www.hp.com/support/tapetools
extended (stop before locking the magazine).
3.
Pull the magazine back out until fully extended.
4.
Load the tape cartridges into the new magazine
Regulatory information
in the same locations they were in previously.
5.
Push the magazine handle slowly until the
For important safety, environmental, and regulatory
magazine release latch snaps into place. The
information, see Safety and Compliance Information
magazine locks into place after it is correctly
for Server, Storage, Power, Networking, and Rack
installed.
Products, available at http://www.hp.com/support/
Safety-Compliance-EnterpriseProducts.
Documentation feedback
Send any errors, suggestions, or comments to
Documentation Feedback (docsfeedback@hp.com).
Page 3
...