Évaluations - 1, GPA: 3
(
)
)
|
Facilité d'utilisation
9 Espanol..................................17 840101400 840101400 ENv02.qxd 5/10/02 1:28 PM Page 2 IMPORTANT SAFEGUARDS When using your flatiron, basic safety precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING 1. Use iron only for its intended use. 2. To protect against risk of electric shock, do not immerse in water or other liquids. 3. The iron should always be turned to OFF before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect. 4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around iron when storing. 5. Always disconnect iron from electrical outlet when filling with water or emptying and when not in use. 6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron. Call our toll-free customer service number for information on examination, repair or electrical or mechanical adjustment. Incorrect reassembly can cause a risk of electric shock when the iron is used. 7. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected or on an ironing board. 8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down–there may be hot water in the reservoir. SPECIAL INSTRUCTIONS 1. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. 2. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over. SAVE THESE INSTRUCTIONS! 2 Consumer Safety Information This product is a household-type iron. This appliance is equipped with a polarized has one blade wider than the other. The plug will fit into an electrical outlet only one way. This is a safety feature intended to help reduce the risk of electrical shock. If you are unable to insert the plug into the outlet, try reversing the plug. If the plug should still fail to fit, contact a qualified electrician to replace the obsolete outlet. Do not attempt to defeat the safety purpose of the polarized plug the plug in any way. Use the iron on an ironing board. Ironing on any other surface may damage that surface. Before First Use • Steam vents should be cleaned before first use. See the “Self-Clean” section on page 7 for more information. • Many irons spit or sputter during the first few uses with tap water. This happens as the steam chamber becomes conditioned. This will stop after a few uses. • During first use of the iron, it may appear to smoke. This will stop and does not indicate a defect or hazard. 3 840101400 ENv02.qxd 5/10/02 1:28 PM Page 4 To Dry Iron 1. Plug iron into outlet. 2. Set the Adjustable Steam Switch to O (the Dry Iron position). 3. Turn Temperature Control Dial to desired temperature. Allow two minutes for iron to reach desired temperature. 4. To turn iron Off, turn Temperature Control Dial to Off and unplug iron. To Steam Iron 1. Unplug iron. Using a cup, slowly pour 5 ounces of tap water into water tank opening. Do not fill iron directly from the faucet. 2. Plug iron into outlet. 3. Turn Temperature Control Dial to desired fabric setting in steam range. Then set Adjustable Steam Switch to the recommended steam level. 4. Allow two minutes for the iron to reach desired temperature. 5. To turn iron off, set Adjustable Steam Switch to O (Dry Iron). Turn the Temperature Control Dial to Off. Unplug iron. 6. Empty water from the iron following directions in “Caring for Your Iron.” 4 Features Auto Shutoff Reset Button/Light The light comes on when the iron is first plugged in. After 15 minutes, the iron will shut off and the light will go out. Push the Reset Button to turn the iron back on. Power On Light This light comes on when the iron is plugged in and remains on until the iron is unplugged. The light stays on even if Temperature Control Dial is turned to Off. Spray and Blast of Steam Buttons Push Blast Button for an extra blast of steam. Push Spray Button to release a fine spray of water for difficult wrinkles in cotton or linen. 5 Reset Button Light Power Light Blast Spray 840101400 ENv02.qxd 5/10/02 1:28 PM Page 6 Features (cont.) Retractable Cord 1. Press and hold the Cord Release Button while pulling cord to desired length. Do not unwind cord beyond the tape indicator on the cord. 2. To store cord, place the iron, soleplate down, on ironing board. Unlatch Retractable Cord Handle and wind clockwise. IMPORTANT! Do not press Cord Release Button while winding cord. Only wind clockwise or the cord may jam. See illustration. 3. If cord jams while winding, push the Cord Release Button to unwind slightly until cord is free. Then slowly start to wind clockwise again. If Retractable ...