Évaluations - 3, GPA: 3.3
(
)
)
|
Facilité d'utilisation
SAFETY MEASURES • Incorrect use of the steam iron may cause personal injury and damage to the kettle. • Use the steam iron for its intended purpose only. The manufacturer is not responsible for any damage resulting from incorrect use or handling (see also Guarantee Terms). • The steam iron may only be connected to 230 V, 50 Hz. • The steam iron or cord must not be submerged in water or any other liquid. • Never leave the steam iron unattended when in use and keep an eye on children. • Allow the steam iron to cool down completely before putting it away. Always keep the steam iron out of the reach of children. • Protect the solepate, and NEVER run it over metal or similar surfaces, as this will damage it. • This steam iron is not suitable for commercial or outdoor use. • Always keep the steam iron at a safe distance from combustible objects when in use. • Never leave the steam iron in a place where the temperature might drop below freezing point. • Do not cover the steam iron. • Do not allow the cord to hang over the table edge, and keep it away from hot objects and naked flames. • Check regularly that neither the cord nor plug is damaged and do not use the steam iron if it is, or if it has been dropped or damaged in any other way. • If the steam iron, cord or plug is damaged, it must be inspected and, if necessary, repaired by an authorised repair engineer, otherwise there is a risk of electric shock. Never try to repair the appliance yourself. • Remove the plug from the socket after use, when cleaning, and when filling the water reservoir. • Avoid pulling the cord when removing the plug from the socket. Instead, hold the plug. • Make sure that it is not possible to pull or trip over the steam iron cord or any extension cord. • Do not put more than 120 ml of water in the reservoir. Do not add anything to the water. Ordinary tap water can be used. KEY 1. Spray nozzle 2. Cover for water reservoir 3. Button for spray function 4. Knob for selecting the steam setting 5. Handle 6. Cord 7. Indicator light 8. Thermostat knob 9. Soleplate 10. Mark for maximum water level 11. Refilling container PRIOR TO FIRST USE • Remove the protective film from the soleplate (9). • Some parts of the steam iron were oiled during manufacture and these will therefore smoke slightly when the iron is first used. This is entirely safe, and the smoke will disappear once the steam iron has been used a few times. Test it on a piece of material or similar before using it on clothes. 5. 4. 3. 6. 2. 1. 7. 8. 10. 9. 11. USE Filling with water (for steam ironing) • Set the thermostat knob (8) to 0 position. • Remove the plug from the socket. • Lift the water reservoir lid (2), and fill with water (max. 120 ml), using the refilling container (11) if you wish. • Close the water reservoir lid. Setting the temperature • Select the required iron temperature using the thermostat knob: • Synthetic fabrics (nylon, polyester, acrylic, etc.) •• Wool, silk or blends ••• Cotton or linen • Place the steam iron on its end, so it stands upright. Plug in and switch the power on. • Do not start ironing until the indicator light (7) goes out. The indicator light switches on and off during ironing, as the thermostat regulates the temperature of the steam iron. • If you turn the temperature up using the thermostat button, you should not start to iron until the indicator light goes out. Steam ironing Steam ironing is only possible at high temperatures. Do not use steam ironing when the thermostat knob is at position •. If you do, water runs out from the soleplate, because the steam iron is not hot enough to convert all the water to steam. • Check that there is sufficient water in the reservoir. • Set the thermostat knob to the required position (at least ••). • Plug in. Start ironing when the thermostat light goes out. • Turn the steam setting selection knob (4) to select the steam setting. You can choose between the following settings: 0 No steam Minimum steam Maximum steam Cleaning (see ‘Cleaning’ section) • The steam iron gives off continuous steam from the soleplate in settings 2 and 3. Begin steam ironing. • Turn the steam setting selection knob to 0 to stop continuous steam. Spray function This function moistens the item you are ironing when you want to remove creases. The function cannot be used unless there is water in the reservoir, or when the indicator light is on. • Press the button for the spray function (3). The steam iron gives off spray from the spray nozzle (1). Dry ironing You dry iron in the same way as you steam iron, except the steam setting selection knob must be in position 0. Tips! • Always stand the iron upright if you take a break from ironing! • Always iron synthetic fabrics and silk on the reverse. This avoids shiny spots on the fabric. • The steam function can also be used when the steam iron is held upright. This is useful if you want to remove marks or creases from hanging garments, curtains, etc. • Wool products (100% wool) may be pre...