Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
• Never spray steam towards other people, as it can cause serious burns and scalding. • Use the steam iron for its intended purpose only. The manufacturer is not responsible for any injury or damage resulting from incorrect use or handling (see also Guarantee Terms). • The steam iron may only be connected to 230 V, 50 Hz. • The steam iron or cord must not be submerged in water or any other liquid. • Never leave the steam iron unattended when in use, and keep an eye on children. • Allow the steam iron to cool down completely, and empty any remaining water, before putting it away. Always keep the steam iron out of the reach of children. • Protect the soleplate, and NEVER run it over metal or similar surfaces, as this will damage it. • This steam iron is not suitable for commercial or outdoor use. • Always keep the steam iron at a safe distance from combustible objects when in use. • Never leave the steam iron in a place where the temperature might drop below freezing point. • Do not cover the steam iron. • Do not allow the cord to hang over the edge of a table/counter, and keep it away from hot objects and naked flames. • Check regularly that neither the cord nor plug is damaged and do not use the steam iron if they are, or if it has been dropped or damaged in any other way. • If the steam iron, cord or plug is damaged, it must be inspected and, if necessary, repaired by an authorised repair engineer, otherwise there is a risk of electric shock. Never try to repair the appliance yourself (see also Guarantee Terms). • Remove the plug from the socket after use, when cleaning, when filling the water reservoir, and when left unattended. • Avoid pulling the cord when removing the plug from the socket. Instead, hold the plug. • Make sure that it is not possible to pull or trip over the steam iron cord or any extension cord. • Do not put more than 300 ml water in the reservoir. Do not add anything to the water. Ordinary tap water can be used. KEY 1. Spray nozzle 2. Refilling container 3. Steam setting selection knob 4. Steam shot button 5. Spray button 6. Auto shut-off indicator 7. Handle 8. Cord 9. Thermostat light 10. Temperature control dial 11. Mark for maximum water level 12. Soleplate 13. Cover for water reservoir 1.2.3.4.5.6.7.8.9.10.11.12.13. 14 PRIOR TO FIRST USE • Check that there is sufficient water in • Remove the protective film from the soleplate (12). • Some parts of the steam iron were oiled during manufacture and these will therefore smoke slightly when the iron is first used. This is entirely safe, and the smoke will disappear once the steam iron has been used a few times. Test it on a piece of material or similar before using it on any clothing. USE Filling with water (only for steam ironing) • Set the temperature control dial (10) to MIN position. • Remove the plug from the socket. • Lift the water reservoir cover (13 – see also image to right) and fill with water (max. 300 ml), using the refilling container (2) if necessary. • Close the water reservoir cover. Setting the temperature • Select the required iron temperature using the temperature control dial: • Synthetic fabrics (nylon, polyester, acrylic, etc.) •• Wool, silk or blends ••• Cotton or linen • Place the steam iron on its end, so it stands upright. Plug in and switch the power on. • Do not start ironing until the thermostat light (9) goes out. The thermostat light switches on and off during ironing, as the thermostat regulates the temperature of the steam iron. • If you turn the temperature up using the temperature control dial, you should not continue ironing until the thermostat light goes out. Steam ironing Steam ironing is only possible at high temperatures. Do not use steam ironing when the temperature control dial is at position •. If you do, water runs out from the soleplate because the steam iron is not hot enough to convert all the water to steam. the reservoir. • Set the temperature control dial to the required position (at least ••). • Plug in. Start ironing once the thermostat light goes out. • Turn the steam setting selection knob (3) to select the steam setting. You can choose between the following settings: a. Automatic cleaning (see ‘Cleaning’ section) b. No steam c. Minimum steam d. Maximum steam • The steam iron produces continuous steam from the soleplate at settings c. and d. Begin steam ironing. • Turn the steam setting selection knob to setting b. to stop continuous steam. Spray function This function moistens the item you are ironing when you want to remove creases. • Press the spray button (5). The steam iron pumps spray from the spray nozzle (1). Dry ironing You can dry iron in the same way as steam ironing, except the steam setting selection knob must be in position b. Tip! • Always stand the iron upright when taking a break from ironing! • Always iron synthetic fabrics and silk on the reverse side. This prevents shiny spots on the fabric. • The steam shot function can also be used when the steam iron is held ...