Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
Do not fill beyond the maximum water level. IRONING WITHOUT STEAM Set the steam regulator (5) to the “0” position (Fig. 3) and slide the temperature control (8) to the desired position. The Spray and Super steam functions may be used if required. IRONING WITH STEAM Unplug the iron from the mains supply. Turn the steam selector (5) to the “0” position (Fig. 3) open the lid on the filling spout (4) and fill the tank (2) with water (Fig. 2). Plug the iron into the mains supply and select a suitable temperature. The pilot lamp (9) will stay lit while the iron is heating up and go out as soon as it has reached the selected temperature. As soon as the iron is hot turn the steam selector (5) to the ( ) position (Fig.4) When ironing with steam, make sure that the temperature control (8) is always bet ween the •• and Max settings. When using the steam iron for the first time, tr y it away from the clothes just in case there is any dirt in the steam chamber. When you have finished ironing, set the steam selector (5) to the “0” position (Fig 3) and empty the tank (2). SPRAY (fig. 6). You can get an additional burst of Spray, whether ironing dr y or with steam, in the following way: -Press the Spray button (6) . Do not use the spray for ironing silk as this may leave water marks. IRONING WITH SUPERSTEAM (fig. 7) Just as with the Spray function you can also get an additional burst of steam when ironing with or without steam by doing the following: -Set the temperature control (8) bet ween the •• and Max settings and wait until the iron reaches temperature. -Raise the iron slightly up off the material and press the super steam button (7) down firmly. -Pause for at least 5 seconds bet ween each jet of steam. SELF-CLEANING CAUTION ! Do this operation over a sink. To keep steam production constant occasional cleaning is recommended as limescale can build up inside the steam ducts and steam chamber. To do this fill the water tank (2), setting the temperature regulator (8) to the “M A X” position. Plug the appliance in and when the lamp (9) goes out press the steam control (5) down to the “Self-clean” position (Fig. 5). Keep the button held down until water stops coming out through the steam holes. As soon as you release the steam control (5) it will automatically go back to the “Max” position (Fig.4) CREASE REMOVAL IN VERTICAL (MOD. PV1405) -Set the temperature control (8) bet ween the •• and Max settings and wait until the iron reaches temperature. -Hang the garment on a hanger and place the iron some 10 -20 cm away. Never iron a garment if somebody is wearing it at the time (Fig. 8). -Press the super steam push button (7) pausing for at least 5 seconds between each press. EMPTYING OUT THE WATER TANK Take the plug out of the mains socket, open the lid on the filling spout and empty out the tank by holding the iron pointed-end down and shaking it gently. STORAGE The iron can be stored away with the cable coiled up in the rear area (Fig. 9). It is advisable to stor...
Ce manuel est également adapté pour les modèles :Fers - PV1405/02 (1.02 mb)