Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
PRO EXPRESS TURBO INSTRUCTIONS FOR USE - STEAM GENERATOR NOTICE D’EMPLOI - GENERATEUR DE VAPEUR GEBRUIKSAANWIJZING - STOOMGENERATOR GEBRAUCHSANWEISUNG - DAMPFGENERATOR BRUGSANVISNING - DAMPGENERATOR BRUKSANVISNING - ANGSTATION KAYTTOOHJE - SILITYSKESKUS ISTRUZIONI PER L’USO - GENERATORE DI VAPORE Nнcтpyкция пo зкcплyaтaции - ПАРОГЕНЕРАТОРЕ 035613 - 45/06 GB 1- UNDERSTANDING YOUR STEAM GENERATOR Steam control button (depending on the model) Temperature control slide for the iron Removable water tank Removable water tank filler cover Iron rest Boiler rinse plug and steam Iron-base steam cord Power cord storage space Thermostat light Steam generator boiler (in the base unit) Handles for removing and replacing the water tank Illuminated on / off switch Turbo steam button Iron retaining hoop Power cord reel button cord fastener clip Control panel Red “removable water tank empty” light Orange “boiler rinse” light “Restart” button Green “steam ready” light Steam output control dial 2- LOCKING SYSTEM FOR RETAINING THE IRON ON THE BASE CLICYour steam generator is equipped with a retaining clip which locks the iron on its casing for easier transport and storage CLICYour steam generator is equipped with a retaining clip which locks the iron on its casing for easier transport and storage Lock Unlock 3- PREPARING YOUR STEAM GENERATOR 1.To carry your steam generator by the iron handle : - place the iron on the iron rest of the generator and raise the retaining hoop over the iron until it locks into place (audible click) (1). - grasp the handle of the iron to carry your steam generator (2). 2. Place your steam generator on a stable, horizontal heat-resistant surface. 3. Grasp the handles of the removable tank and pull horizontally to remove it (3). 4. Fill up the water tank taking care not to exceed the maximum level just below the filler cover (4). 5. Replace it firmly in its housing, making sure it is fully into place (5). CLICK1 2 3 4 5 Your iron has been designed to operate using untreated tap water. • Heat concentrates the elements contained in water during evaporation.The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilledor demineralised water or rain water should not be used in your iron.Also do not use boiled, filtered or bottled water. If your water is very hard mix 50% untreated tap water and 50% distilled or demineralised water. The water to use in your steam generator : 4- USING YOUR STEAM GENERATOR 1. Push the retaining clip forward to release the iron(6). 2. Completely unwind the power cord from its storage space before connecting to an earthed socket (7). 3. Press on the on / off switch (located on the side of the base unit) (a): the green light (located on the control panel) flashes and the boiler heats up (b).It will take around 2 minutes for steam to be produced which is indicated when the green “steam ready” light stops flashing (8). 6 (a) (b) 7 8 • The first time the appliance is used, there may be some fumes and smell but this is not harmful. They will not affect use and will disappear rapidly. 5- OPERATING THE CONTROL PANEL • Flashing green light : the water is heating up in the boiler. • “Restart” button: • Continuous green light : - to be pressed after each refill of the water tank steam is ready for use. to start ironing again (see paragraph 7), • Continuous red light : - to be held pressed after rinsing the boiler the water tank is empty. (see paragraph 11). • Orange “boiler rinse” light flashes : your boiler needs rinsing. Note: the appliance must be cold (see section 11). 6- USING YOUR STEAM GENERATOR • Place the iron's temperature control slide according to the type of fabric to be ironed (see table + 9). • The thermostat light comes on. Be careful ! The steam generator is ready when the thermostat light goes out and when the green “steam ready” light stays on. • Adjust the steam output control dial (located on the control panel - 10). • While ironing, the light on top of the iron and the steam ready light turn on and off, according to the heating needs without any disturbing the use. • To obtain steam, press on the steam control button on top of the iron handle and keep it pressed (11).The steam will stop when you release the button. • When starting, and regularly while it is being used, your steam generator's electric pump injects water into the boiler. It makes a noise but this is quite normal.You may also hear a clicking noise which is the steam valve opening.Again this is normal. • Always spray starch onto the reverse side of the fabric to be ironed. linencottonlincotonlainesoiesynth. woolsilksynthetic9 10 11 Do not place the iron on a metal support.When taking a break from ironing, always place the iron on the iron rest plate of the unit. It is equipped with non-slip pad...
Ce manuel est également adapté pour les modèles :Fers - PRO EXPRESS (613.24 kb)