Évaluations - 2, GPA: 3.5
(
)
)
|
Facilité d'utilisation
• This appliance is provided with a voltage selector, it can be used on 120 V/230 V main power. This appliance will be set at the factory at 120 volts. Be sure dual voltage selector is in correct position before operating (refer to the General Information Section). • To protect against a risk of electric shock, do not immerse the iron in water or other liquids. • The iron should always be turned OFF before plugging or unplugging from outlet. Never pull cord to disconnect from outlet; instead, grasp plug and pull to disconnect. • Do not allow cord to touch hot surfaces. Let iron cool completely before storing. Loop cord loosely around iron when storing. • Always disconnect appliance from electrical outlet when filling with water or emptying and when not in use. • To reduce the risk of contact with hot water emitting from steam vents, test the steamer before each use by holding it away from the body and pressing the steam button. • Close supervision is necessary for any appliance being used by or near children. Do not leave appliance unattended while plugged in. • To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. • Do not operate Travel Iron/Steamer with a damaged cord or if the appliance has been dropped or damaged. To avoid the risk of electric shock, do not disassemble. All repair work should be done by an authorized Oreck Service Center. • This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. • Do not use attachments not intended or recommended for this appliance. • Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down – there may be hot water in the water tank. • Before removing or attaching any accessories, unplug the appliance from the electrical outlet and let it cool. • Never iron or steam clothes while they are being worn. 1 When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING To reduce the risk of fire, electric shock, or injury: • Never switch the dual voltage selector while the appliance is in use. • This appliance was set at the factory to operate at 120 volts. Refer to the General Information section of this manual for conversion to 230 volt operation. • Empty water from the iron before storing it. Point the unit downward over a sink and turn upside down to drain. Push steam button a few times and lightly shake iron after use to ensure all water is drained. The remaining moisture will evaporate if the unit is plugged in and heated for a few moments. • If an extension cord is absolutely necessary, a 15-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it can not be pulled or tripped over. SAVE THESE INSTRUCTIONS Household Use Only ALL SERVICING SHOULD BE DONE BY AN AUTHORIZED ORECK SERVICE CENTER. CUSTOMER SERVICE HOT LINE US: 1-800-989-3535 Canada: 1-888-676-7325 IMPORTANT SAFETY INSTRUCTIONS CONTINUED IMPORTANT SAFETY INSTRUCTIONS CONTINUED Warranty Oreck Corporation warrants the Travel Iron/Steamer (Model JP777) free from defects in material and workmanship under normal, non-commercial use and service. Oreck will remedy any such defects if they appear within one (1) year from date of purchase. This warranty gives you specific legal rights, and you may have other rights, which vary, from state to state. 2 Assembly Before Initial Use 1. Before each use, always remove the detachable lint remover and verify the voltage rating on the appliance corresponds to the voltage in your home or hotel. Replace the Lint Remover. 2. Some parts of the appliance have been slightly greased and as a result the unit may smoke slightly when switched on for the first time. After a short while, however, this will cease. 3. Normal tap water can be used, but if you live in a hard water area, using distilled water is recommended to insure optimum performance of the unit. 4 56 8 9 11 12 13 14 1 2 16 17 15 3 7 10 To assist you in identifying components of your Travel Iron/Steamer, the parts have been numbered as follows: 1. Steam Burst Button 2. Cord Protector/Power Cord 3. Water Tank Release Button 4. Water Tank Lid 5. Detachable Handle Cover/Water Tank 6. Handle Base 7. Temperature Indication Point 8. LED Light 9. Temperature Control Knob 10. Voltage Selector 11. Housing 12. Handle Release Button 13. Base Plate 14. Soleplate 15. Detachable Lint Remover 16. Detachable Clothes Brush 17. Measuring Cup General Information 3 (Fig. A) Voltage Selection This appliance is provided with a voltage selector. It can be used on 120VAC or 230VAC main power. This appliance will be set to ...