Évaluations - , GPA: ( )

Instructions GE Monogram, Modèle 790.99013

Fabricant : GE Monogram
Taille : 2.82 mb
Nom Fichier : L0211265.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Figure 3 Figure 4 Surface Cooking Settings Recommended Settings for Single, Bridge and _ Radiant Dual Surface Elements surface elements may appear to have cooled after they have been turned off. The Setting Type of Cooking glass surface may still be HIGH (8-Hi) Start most foods, bring water to a boil, pan broiling hot and burns may occur if the glass surface is touched MEDIUM HIGH (5 -8) Continue a rapid boil, fry, deep fat fry before it has cooled sufficiently. MEDIUM (3 -5) Maintain a slow boil, thicken sauces and gravies, steam vegetables Iri_'=!l_l'_ Do not place plastic items such as salt MEDIUM LOW (2 -4) Keep foods cooking, poach, stew and pepper shakers, spoon LOW (Lo -2) Keep warm, melt, simmer holders or plastic wrappings on top of the Figure 5 range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements. Setting Surface Controls Radiant surface elements FEATURE OVERVIEW may appear to have cooled after they _ o_. "Le i_ H"ave u"een "urne" u_/Hy_ -'ass su -=ace ESEC Hot Element Indicator Message (HE) may still be hot and burns may occur if ESEC Flashing Error Message (Er) the glass surface is touched before it ESEC Lockout Feature (--) has cooled sufficiently. Operating Single Surface Radiant Elements ESEC Hot Element Indicator Message (HE) After using any of the single, dual or Bridge radiant element positions the cooktop will become very hot. Even after turning the control knob to OFF, the cooktop will remain hot for some time. The ESEC control monitors the temperature of the cooktop and displays the message "HE" (hot element) warning when the cooktop is still too hot to touch (See Fig.l). If the HE message appears in the window, the control can still be turned on again for use. ESEC Error Indicator Message (Er) An error message will be displayed (flashing "Er') at power up (or after a power failure) if ANY of the surface control knobs were left in the ON positions. If a power failure should occur, be sure to set all of the 4 surface control knobs to the OFF position (See Fig. 2). This will reset the surface controls. Be sure to reset the clock (See page 16). Once the surface controls have been set to the OFF positions and the clock has been set with the correct time of day, the surface controls should return to normal operation. If the surface controls do not funcfion and the "Er" message remains in any display after following these procedures, contact Sears Service for assistance. ESEC Lockout Feature ( --) The self-clean feature will not operate whenever a radiant surface element is ON. The ESEC feature will not operate during a self-clean cycle or when the Oven Lockout feature is active. Whenever the ESEC Lockout feature is active, "--" may appear in any display window (See Fig. 3). If any of the surface elements are still hot during active Lockout, "HE" wilt appear in the window instead of the "--" message. Operating Single Radiant Surface Elements The cooktop has single radiant surface elements at 2 locations; the right rear (Fig. 5) and left rear ...