Évaluations - 2, GPA: 4
(
)
)
|
Facilité d'utilisation
2. Place the correct Burner Caps at each of the burner locations. Each of the Burner Heads MUST have a Burner Cap installed to insure proper ignition and gas flame size (See Figure 2). 3. Place the 2 (two) or 3 (three) cast iron Burner Grates supplied with the range. Carefully lift the burners grates on to the cooktop over the burners. Properly installed Burner Grates will rest with all Grate legs on the cooktop. REMEMBER --DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. 7 Setting Surface Controls Dual Burner Head Assembly (present on Models 790.3248 & 790.3249 only) Step 4 Make sure that the Burner Head, Burner Caps and Burner Skirt are installed properly and at the correct locations. Burner Outer 1. Follow the Installation Instructions before installing and using your new Cap Hole Step 3 range. 2. Remove all packing tape from cooktop and the dual burner. Burner / 3. Discard all packing material located under all Burners (if applicable). / Skirt "., 4. To install Burner Head, Caps & Skirt, refer to figure 1 and follow the Burner following steps: Burner Headpin E_ i__ -I_ Head Step 1:Align Burner Head Pin A on Burner Base Hole. PinA Step 2: Place Burner Skirt around Head and Base. Step 3: Align out Burner Outer Cap Hole into Burner Head Pin B. Burner Head o_ Step 2 Step 4: Place Inner Burner Cap centered on Burner Base. Burner 5. Put back the grates on the cooktop. Base REMEMBER--DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS Burner Hole OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. Base _. *_X._, Step 1 Figure 1 Control Locations of the Gas Surface Burners Your cooktop is equipped with gas surface burners with different BTU ratings. The ability to heat food quicker and in larger volumes increases as the burner size increases, The small SIMMER burner is best used for simmering delicate sauces, etc. This burner is located at the right rear burner position on the cooktop. The STANDARD burners can be used for most surface cooking needs. The one or two (36" models only) burners are located at the left rear and center rear positions on 36" models. The POWER burner is best used for bringing large quantities of liquid rapidly up to temperature or when preparing larger quantities of food. The POWER Figure 2 (model 790.3248 shown only ) burner is located at the right front and left front burner position on the cooktop. Regardless of size, always select cookware that is suitable for the amount and type of food being prepared. Select a burner and flame size appropriate to the pan. Never allow flames to extend beyond the outer edge of the pan. Figure 3 (model 790.3249 shown only) 8 Setting Surface Controls Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the ran...
Ce manuel est également adapté pour les modèles :Hobs - 3244 (2.42 mb)
Hobs - 3249 (2.42 mb)
Hobs - 3248 (2.42 mb)
Hobs - 3244 (2.42 mb)