Évaluations - 3, GPA: 4.3
(
)
)
|
Facilité d'utilisation
Installing Do not install the hob if the ceramic glass is damaged or cracked. This hob must be installed according to the instructions supplied. Any installation work must be undertaken by a qualified competent person. Do not alter the specifications or attempt to modify the appliance in any way. During Use The hob is intended for domestic cooking only. It is not designed for commercial/industrial purposes. Ensure that all the control knobs are in the OFF position when not in use. Do not use the hob if it is damaged in any way, contact your local AEG Service Centre. Never use plastic or aluminium dishes on the hob. Never leave the hob unattended while deep fat frying, or heating fats and oils. The appliance is not intended for use by young children or infirm persons without supervision. Child Safety Young children should be supervised to ensure that they do not play with the appliance The hob gets hot when it is in use. Children should be kept away until the hob has cooled. Maintenance and Cleaning Only clean this hob in accordance with the instructions given in this book. Service Repairs carried out by inexperienced persons may cause injury or serious malfunction of the appliance. Repairs must only be carried out by a qualified/competent person. Contact your local AEG Service Centre. Disposal Make the hob unusable by cutting off the cable. Dispose of any packaging material and old appliances at an authorised disposal site. Description of the product Panel % . Ceramic glass surface The ceramic glass surface has four cooking zones. When a zone is turned on, it will illuminate at various intervals depending on the heat setting selected. Even at the highest setting the zone is disconnected occasionally to ensure that the surface is not over-heated. The glass is hard, and has been tempered to withstand heat, cold and temperature shocks. But like all glass it is sensitive to impact. Do not stand on the ceramic glass surface. At the front of the ceramic glasssurface in the middle there are four fields. Each field corresponds to a cooking zone. When using a zone, the field concerned will show which CHEC function you are using and the setting at which you have set the zone. Cooking zones There are two single zones and two double zones. CHEC control Information about how to use the CHEC control function can be found in the section entitled “Operation instructions”. The CHEC control function allows electronic control of the zones. CHEC control enables you to set the heat with great precision, which means that you do not have to adjust the heat constantly. CHEC control provides the zones with the following functions: Automatic disconnection of “forgotten” zones. AUTOMAX at all settings. Setting of large zone on double zones. Child safety device on zones. Residual heat indicator When you switch off a zone, an "H" in the display indicates that the zone is still hot. The residual heat indicator will continue to be illuminated until the zone reaches a temperature of approx. 80°C. Before use Connection of child safety device on zones Turn the 2 control buttons to at the same time. The display will show: When you turn on a zone the display will show: To turn on a zone, turn the 2 control buttons to at the same time. You must then activate one of the zones within 10 seconds. The light under the symbol in the display will disappear. You can disconnect the child safety device permanently as follows: 1. Turn the 2 control buttons to and return to 0. 2. Turn one of the 2 control buttons immediately to . S A F E Protection of the glass ceramic surface A protective film should be applied to the glass ceramic surface before use. This will make it easier to clean the surface, as well as preventing substances from being burnt onto the surface. This is what to do: 1. Pour a few drops of ceramic cleaning detergent such as vitroclen onto a piece of kitchen roll and rub the detergent into the entire surface. 2. Polish the surface with a clean cloth until it is dry. How to use Switch symbols (to the left) control for regulating the small cooking zone at the rear control for regulating the double cooking zone at the front. control for regulating the large cooking zone at the rear control for regulating the small cooking zone at the front. Regulating The regulation of heat is step-free for all plates on a scale from 1 to 9. “1” Represents lowest heat “9” Represents maximum heat. “0” Represents “OFF”. Double cooking zone Small circle: When you control on the cooking section it will always be the small circle that is controled on. Choose the wanted temperature. From small to big circle (both circles are on): Turn the button past “0”. Turn back to the wanted temperature. From big to small circle: Turn the button back to “0”. Control on again and choose the wanted temperature. Residual-Heat indicator When you switch off a zone, an "H" in the display indicates that the zone is still hot. The residual heat indicator will continue to be ...
Ce manuel est également adapté pour les modèles :Hobs - 6510K7-M (255.42 kb)
Hobs - 6510K7-M (255.42 kb)
Hobs - 6510K7-M (255.42 kb)