Évaluations - 4, GPA: 4.8
(
)
)
|
Facilité d'utilisation
• When disposing of an old appliance, make it unusable, by cutting off the cable. • The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. These instructions are only valid for countries whose identification symbols are shown on the cover of this instruction booklet and on the appliance itself. Keep this instruction book for future reference and ensure it is Keep this instruction book for future reference and ensure it isKeep this instruction book for future reference and ensure it isKeep this instruction book for future reference and ensure it isKeep this instruction book for future reference and ensure it isKeep this instruction book for future reference and ensure it is passed on to any new owner passed on to any new ownerpassed on to any new ownerpassed on to any new ownerpassed on to any new ownerpassed on to any new owner. ..... 6 Description of the Hob 1. Hob Top 2. Auxiliary Burner 3. Semi-rapid Burner 4. Rapid Burner 5. Triple Crown 6. Control knobs 1 3 6 4 5 2 3 Instructions for the User INSTALLATION Any gas installation must be carried out by a registered Any gas installation must be carried out by a registeredAny gas installation must be carried out by a registeredAny gas installation must be carried out by a registeredAny gas installation must be carried out by a registeredAny gas installation must be carried out by a registered competent person, and in accordance with existing rules competent person, and in accordance with existing rulescompetent person, and in accordance with existing rulescompetent person, and in accordance with existing rulescompetent person, and in accordance with existing rulescompetent person, and in accordance with existing rules and regulations. and regulations.and regulations.and regulations.and regulations.and regulations. The relevant instructions are to be found in the second section of this manual. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. WHEN THE HOB IS FIRST INSTALLED Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. 8 Lighting the burners For easier lighting, proceed before putting a pan on the pan support. To light a burner: .. turn the relevant knob anti-clockwise to maximum position ( ), then push it down to ignite the burner. .. Upon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" (see diagram - letter D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. .. Then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. If you cannot light the flame even after severalattempts, check the "cap" (see diagram - letter A) and the"crown" (see diagram - letter B) are in the correct position. .. Operation Hob burners control knobs The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply A - Burner cap B - Burner crown C - Ignition electrode D - Thermocouple A B C Triple crown burner D Do not keep the control knob pressed for more than 15 seconds. If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position and wait for at least one minute before trying to light the burner again. When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically. In the absence of electricity In the absence of electricityIn the absence of electricityIn the absence of electricityIn the absence of electricityIn the absence of electricity, ignition can occur without the electrical device; in this case, approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the maximum position. If the control knobs become difficult to turn, please contact your local Service Force Centre. Using the hob correctly Using the hob correctlyUsing the hob correctlyUsing the hob correctlyUsing the hob correctlyUsing the hob correctly To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a flat flatflatflatflat flat bottom fitting the s...
Ce manuel est également adapté pour les modèles :Hobs - ZGS 782 ICT (579.13 kb)
Hobs - ZGS 782 IT (579.13 kb)
Hobs - ZGS 782 IT (579.13 kb)
Hobs - ZGS 782 IT (579.13 kb)