Évaluations - , GPA:
(
)
)
Fabricant : Cateye
Taille : 149.26 kb
Nom Fichier : AT100N_v1_e.pdf
Langue d'enseignement: 
Le document est chargé, s'il vous plaît patienter
 |
Le document est chargé, s'il vous plaît patienter
Facilité d'utilisation
............ 10666001101 _ __ m ■ ■ m b ■ Copyright© 2001 CAT EYE Co.,Ltd. ABOUT INSTALLATION CCMAT10104171 p =Sn In order to make this model suitable for MTB, some of the parts have been changed. When mounting to bicycle, follow the explanation written in this sheet, not the instruction manual. Parts O Bracket ©Wire © Sensor © Magnet © Bracket Rubber Pad (2 pcs © Nylon Tie (5 pcs.) © Spiral Tube © Lithium Battery CR2032 1. Installation (Instead of following the explanation in 11-12 pages of the instruction manual, follow the explanation below.) I IMPORTANT front fork Attach the sensor and the magnet properly so that their positions meet the following conditions [A] and \B\. [Âl Align the magnet’s center and the sensor’s marking line while rotating the wheel. m The clearance between the sensor and the magnet should be less than 5mm. marking line magnet’s center Fig. 1 B front fork magnet Fig.2 less than 5mm 1. Attach the sensor temporarily, with the adhesive tape, to the inside of the right front fork (fig. 3). 2. Attach the magnet to the right side spoke of the front wheel (fig. 4). Align the magnet’s center and the sensor’s marking line (fig. 1). 3. Adjust the position of the sensor so that the clearance between the sensor and the magnet is less than 5mm (fig. 2). Fix the sensor with the nylon ties (fig.5). Cut off the excess. magnet adhesive tape bracket 4. Secure the wire along the fork with the nylon ties (fig. 6), and along the outer cable with the spiral tube. Allow enough wire clearance in the area marked with