Log:
Évaluations - 3, GPA: 4 ( )

Instructions AEG, Modèle 302D

Fabricant : AEG
Taille : 936.52 kb
Nom Fichier : ce92fa59-d53e-e7b4-a50d-10e40d4f29e2.pdf
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


It is changed when the top colouring appears on the bottom, i.e. you can see the colour through the filter grille. To remove the filter: a) Remove the filter grille (see fig. 3) b) Take out the saturated filter after removing the clamps Z (fig. 13). c) Fit a new grease filter and replace filter grille. When replacing the grease filter, also wash the filter grille with warm water and mild detergent i.e. washing-up liquid. Replacement grease filters are available from AEG Spare Parts - Telephone (0753) 872550. The carbon filter is fitted when the hood is used in the recirculating mode. This is not washable and cannot be reused. The carbon filter should be replaced at least once every four months. To remove the carbon filter, push the push-buttons E inwards and pull the filter downwards (Fig. 4). Please specify model number and product number when ordering a replacement filter. This is found on the rating place located inside the hood. Replacement filters are available from AEG Spare Parts, Telephone (0753) 872550. To clean the outside of the hood use a mild solution of washing-up liquid and water. Never use abrasive detergents, brushes or scouring powders. Important Always switch off the hood and pull out the plug before cleaning. 16 ATTENTION Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause a fire as a result of grease deposits. Therefore please observe these recommendations. 1) Disconnect the hood from the electricity supply. 2) Remove the filter grille (fig. 3) - this will then allow inspection/ change of the bulb/s. 3) Unscrew defective bulb and replace with new one. Important: always use 40W candle lamp (E14) bulbs. Before calling the Service Engineer because the hood fails to light up, make sure the bulbs are screwed in tightly. Dimensions Height — 400mm Width — 599mm Depth —270mm Weight Net 9,7Kg Connected Load 200W Fan Motor 120 W Lighting: 40 Watt Candle Lamp x 2 Lengt of the cable: 140 cm Fan speed: 1 2 3 Extractor version: 143m3/h 171 m3/h 234 m3/h Filtre version: 87 m3/h 132m3/h 167m3/h Special Accessories Wall/Window Box Number 647 000 020 Venting Hose 120mm x 2.4M 647 000 012 Venting Hose 100mm x 2.4M 647 000 010 Universal Grease Filter 660 951 157 Carbon Filter KLF 60/80 610 899 421 Changing the bulbs Technical Data Performance Data Faults In case of any enquiries and faults, please call AEG After-Sales Service: AEG Domestic Appliances Limited Head Office: 217 Bath Road Slough, Berks SL1 4AW Tel: 01753 872506 Telefax: 01753512271 AEG Northern Service Centre: Unit 20, Haigh Park Haigh Avenue Stockport GL Manchester SK4 1QR Tel: 0161 487 2205 Telefax: 0161 474 1191 Service Appointments Bristol: 01179 252880 Norfolk: 01603 765515 When calling please state the following 1. The model number 2. The E-Nr. 3. The F-Nr. The manufacturer reserves the right to make alterations in design and colour in the interests of technical developmen...

Ce manuel est également adapté pour les modèles :
Ventilateurs - 302D (936.52 kb)
Ventilateurs - 302D (936.52 kb)
Ventilateurs - 302D (936.52 kb)
Ventilateurs - 302D (936.52 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories