Évaluations - 2, GPA: 4
(
)
)
|
Facilité d'utilisation
If the hood is to be used in filter version, then fix the deflector F to the chimney support bracket G and connect the other extremity of the pipe to the connection ring placed on the deflector F. 16. Make the electrical connections. 17. Apply the chimney stacks and fasten them at the top to the chimney support ,,G‘‘ (17b) using 2 screws (17a). 18. Slide the bottom section of the chimney down until it completely covers the suction unit and slots into the housing provided on top of the hood. Replace the grease filter/s (and where foreseen the grease collecting panels) and check that the hood is operating correctly. Electrical connection The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. Description of the hood - Fig. I 1 Control panel 2 Grease filter 3 Lamp 4 Vapour screen 5 Telescopic chimney 6 Air outlet (used for filter version only) Operation o o o o 12 3 4 1. on/off light switch 2. key OFF/ON suction and power selection of suction 1 2. + 3. power selection of suction 2 2. + 3. + 4.power selection of suction 3 Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for S minutes prior to cooking and to leave in operation during cooking and for another IS minutes approximately after terminating cooking. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost S sec. by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service. Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply. Cleaning the hood The cooker hood should be cleaned regularly internally and externally. For cleaning use a cloth moistened with denatured alcohol or neutral liquid detergents. Avoid abrasive detergents. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. Therefore we recommend oserving these instructions. Grease filter This must be cleaned once a month using non aggressive detergents, either by hand or in the dish-washer, which must be set to a low temperature and a short cycle. When washed in a dish-washer, the grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the grease filter, pull the spring release handle (f) - (Fig. I). Charcoal filter (filter version only) It absorbs unpleasant odours caused by cooking. The charcoal filter can be washed once every two months using hot water and a suitable detergent, or in a dish-washer at 65°C (if the dishwasher is used, select the full cycle function and leave dishes out). Eliminate excess water without damaging the filter, then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100° C to dry completely. Replace the mattress every 3 years and when the cloth is damaged. Remove the filter holder frame by turning the knobs (g) 90° that affix U the chimney to the cooker hood (Fig. 2). Insert the pad (i) of activated carbon into the frame (h) and fit the whole back into its housing (j). Replacing lamps ■ Fig. 3 Warning! Prior to touching the light bulbs ensure they are cooled down. 1. Extract the guard by levering it off with a small screwdriver or similar tool. 2. Replace the damaged light bulb. Only use halogen bulbs of 20W max (G4), making sure you do not touch them with your hands. 3. Close the lamp cover (it will snap shut). If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. Caution The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. WARNING - Ensure thatthe appliance is switched off before replacing the lamp to avoid the possibility of electric shock. Do not use the cooker hood where the grill is not correctly fixed! The suctioned air must not be conveyed in the same channel used for fumes discharged by appliances powered by other than electricity. The environment must always be adequately aerated when the cooker hood and other appliances powered by other than electricity are used at the same time. Flambé cooking with a cooker hood is prohibited. The use of a free flame is damaging to the filters and may cause fire accidents, therefore free flame cooking must be avoided. Frying of foods must be kept under close control in order to avoid overheat...