Évaluations - 1, GPA: 5 ( )

Fabricant : Hotpoint Taille : 1.15 mb Nom Fichier : Langue d'enseignement:

Replace the charcoal filter with one of the same type by carrying out the operations in reverse order. Replace the charcoal filter on average every 6 months depending on how heavily the hood is used. Replacing the lamps Pay particular ATTENTION when carrying out this operation and remember to remove the voltage. After having removed the grease filters, remove the light fitting, operating manually from inside the hood. Apply light pressure to the mobile part of the 2 retainers and release it from the outside. GB Unscrew the bulb and replace it with a bulbof the same type. Re-assemble the light fitting by pushing it into its seatfrom the outside. 7 Precautions and tips 04307518 GB General safety ! The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into account. ! The hoods in insulation class 2 (model HS63X) do not need to be connected to earth. ! The hoods in insulation class 1 (Mod. HS73XHS93X- HSD93I): must be connected to earth. When making the electrical connections, check that the current socket has a ground connection. ! Avoid using materials which could cause spurts of flame (flambees) near the appliance. ! When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect. ! Do not use uncovered electric grates. ! Do not place excessive weights above the hood. Air vent Should you install the ducting version, prepare the air vent hole and duct. In the Ducting version, to get optimal conditions the air venting pipe should: be as short as possible, have the lowest number of bends (max bende angle: 90°, be made of material approved by local authorities (according to the State), have its inner side as regular and smooth as possible. It is moreover recommended to avoid drastic changes of pipe cross section (recommended diameter: 150 mm). ! The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other than electricity (central heating systems, thermosiphons, water-heaters, etc.). ! Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct. In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose. ! The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity (gas, oil, coal heaters, etc) operate at the same time. In fact the ducting hood, disposing of air, could create a vacuum in the room. The vacuum should not exceed 0,04mbar. This prevents the gas exhausted by the heat source from being intaken again. It is therefore advisable to ensure the room contains air taps able to ensure a steady flow of fresh air. Disposal The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted munic...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :