Évaluations - 4, GPA: 3.3 ( )

Fabricant : Creda Taille : 635.77 kb Nom Fichier : Langue d'enseignement:

If ° load rating only is required the installer should move the black wire as indicated in the circuit diagram. ELEMENT ASSEMBLY (WITH SAFETY CUT OUT) WARNING Remove the inner front panel; this carries on it's inner face the front insulation slab. Handle this with care, the insulation must not be damaged. REMOVE ALL THE PACKING CARDBOARD FROM INSIDE THE STORAGE BRICK COMPARTMENT, IF LEFT INSIDE IT WILL BE SET ON FIRE WHEN THE HEATER IS SWITCHED ON. ENSURE THAT ALL PACKAGING MATERIAL IS REMOVED FROM THE BRICKS BEFORE FITTING THEM. Temporarily remove one central element to provide access for the rear rank of bricks. Loosen terminals on one of the elements and remove this to allow installation of rear rank of storage bricks. On heaters with 3 or 4 elements remove one of the central ones. Note the way the bricks are positioned in the heater. Otherwise they will not fit. Put in place the rear rank of bricks, pushing them well back against the rear insulation. Replace the element, making sure that the connection is tight. Now, place in position the front rank of bricks, again pushing them back to make room for the front insulation slab which is attached to the front panel. Check that the front insulation slab is properly attached to the inner front panel and refit panel (insulation innermost) to the heater by locating its bottom edge behind the front lip of the chassis, and inserting retaining screws Glong the top and both sides. With the bricks pushed well back, as mentioned earlier/ and the insulation properly aligned, there should be no bulging of this panel and no undue force necessary to fix it. Refit the lower front pane! by aligning the four side screws before refitting the front face screws. With the lower front panel in place/ the outer panel assembly can be hooked over the rear panel top flange and the screws top and bottom replaced and tightened. Take care not to trap wires or the thermostat capillary between the panel flanges. Ensure all washers are replaced in their original positions. Refit the control knobs under the lift - up flap, taking care to align the flat on each spindle. PLEASE ENSURE THAT ALL POLYSTYRENE AND CARDBOARD PACKING PIECES HAVE BEEN REMOVED. ENSURE WALL BRACKET SCREWS ARE TIGHTENED FULLY WARNING. When a new heater is run up to temperature/ the materials will produce a slight smell for the first few days/ these are normally harmless in a well ventilated room. It is best to make these first overnight charges with the 'Input' control knob at 'Maximum'. Caged birds, young children and people with chest ailments are best kept out of the room for this first period. output Supaslim Combi * 6 n\j 1 mm m SETTING THE CONTROLS The controls are located under the lockable flap at the right hand corner of the top panel. To adjust the controls on the heater use a coin and engage it in the slot provided on the top surface of the knob. AUTOMATIC CHARGING DEVICE (AUTO-SET Fitted only on 'ACW' models) The Auto-Set Co...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :