Log:
Évaluations - 3, GPA: 4 ( )

Instructions Xpelair, Modèle L522212

Fabricant : Xpelair
Taille : 193.97 kb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Par ce dispositif a également d'autres instructions :

Facilité d'utilisation


KNOCK-OUTSBLOWERRECEPTACLE(S) Location of knock-outs. Location of receptacle(s). wolfappliance.com/specs 4) Locate the cord assembly provided with the blower. The cord assembly has two leads, black (L1) and white (neutral). Connect these leads to the leads from the blower, black to black and white to white. Connect all green and bare wires together to the ground screw in the electrical box. 5) Plug the cord assembly into the receptacle located near the center of the hood liner. Refer to the illustra- tion below. Use the clips on the interior of the hood to secure excess power cord. 6) Place all wiring connections inside the electrical box and reinstall the cover. Make sure all wires are secure and that no wires are pinched between the cover and electrical box. IMPORTANT NOTE: Before turning the power on to the ventilation hood liner, make sure the blower is off. Do not run wiring through the ductwork. Pro Hood Liner Installation Complete the Installation INSTALL FILTERS To install the filters, orient each filter with lines running vertically. Position the top edge of the filter as shown in the illustration below. While pressing up against the spring, rotate the bottom edge of the filter into position next to the grease cup. Gloves should be worn when handling filters. INSTALL LIGHT BULBS A suction-cup-style light bulb changer is provided with pro ventilation hood liners. Using this device, push the light bulb into the receptacle and rotate clockwise one- quarter turn. Refer to the illustration below. GREASE CUP FILTER SPRING SIDE VIEW LIGHT BULB CHANGER Filter installation. Light bulb installation. Troubleshooting IMPORTANT NOTE: If the pro ventilation hood liner does not operate properly, follow these troubleshooting steps: • Verify that electrical power is being supplied to the hood liner. • Check electrical connections to ensure that the installation has been completed correctly. • Refer to the troubleshooting guide in the Wolf pro ventilation hoods use & care guide. • If the hood liner still does not operate properly, contact Wolf factory certified service. Do not attempt to repair the hood liner yourself. Wolf is not responsible for service required to correct a faulty installation. Service Information wolfappliance.com/specs Service Information If service is necessary, maintain the quality built into your pro ventilation hood liner by contacting Wolf factory certified service. For the name and number of Wolf factory certified service nearest you, check the contact & support section of our website, wolfappliance.com or call Wolf customer care at 800-222-7820. When calling for service, you will need the model and serial numbers of the hood liner. This information is found on the product rating plate, located inside the left wall of the hood liner shell. Refer to the illustration below. RATINGPLATE Location of rating plate (inside liner). Before servicing or cleaning, switch power off at the service panel and lock the service disconnecting mea...

Ce manuel est également adapté pour les modèles :
Ventilateurs - L342212 (193.97 kb)
Ventilateurs - L582212 (193.97 kb)
Ventilateurs - L402212 (193.97 kb)
Ventilateurs - L462212 (193.97 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories