Log:
Évaluations - 1, GPA: 4 ( )

Instructions Electrolux, Modèle MCH 660

Fabricant : Electrolux
Taille : 692.4 kb
Nom Fichier : 68618f00-e047-47ff-b830-204caad4c9fd.pdf
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


Synthetic Paper Grease Filter The synthetic paper grease filter cannot be cleaned. It must not be washed. To Replace the Synthetic Paper Grease Filter 1. Open the glass visor. 2. Press inwardly on the two slide catches and the grille will open from the front. 3. Slide the right edge of the grille forward until it clears the guide and then unhook the left hinge pin. 4. Carefully ease out the metal wire retaining clips as illustrated opposite. 5. Clean the metal grille and clips before replacing the filter. Handle the wire clips with care and keep away from children as they have sharp points. 6 Charcoal Filter The charcoal filter cannot be cleaned. The filter should be replaced at least every three months or more frequently if the hood is used more than three hours per day. To Remove/Replace the Charcoal Filter 1. Remove the metal inlet grille. 2. Carefully turn the disk (C) anti-clockwise and remove the the charcoal filter (B) from the motor support (A) as illustrated opposite. 3. Clean the metal inlet grille and motor support before replacing the charcoal filter. 4. Place the new charcoal filter (B) over the motor support (A), and while holding the filter securely insert the disk (C) and turn clockwise. Changing the Light Bulb If the light bulb fails to function check that the bulb is screwed into the holder. If bulb failure has occurred then it should be replaced with a 220-240V 40W clear cylindrical shape bulb with a small E14 screw thread. Charcoal filters, grease filters and light bulbs can be obtained from your local Service Force Centre This appliance can be a fire hazard if the grease and charcoal filters are not replaced as recommended. 7 SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start • Check the hood is connected to the electricity supply. • Make sure the switch is in the ‘ON’ position. The cooker hood is not working effectively • The fan speed is set high enough for the task • The grease filter is clean. • The kitchen is adequately vented to allow the entry of fresh air. • If set up for recirculation, check that the charcoal filter is still effective. • If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation • The safety cut-out device has been tripped. • Turn off the hob and then wait for the device to reset. If after all these checks, the fault persists, contact your local Service Force Centre, quoting the model and serial number. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. SERVICE AND SPARE PARTS If you require an engineer or spare parts contact your local Service Force Centre by telephoning: 08705 929929 Your telephone call will be routed to your local Service Force Centre. The addresses are listed in the back of the book. Moffat has an agreement with Electrolux who will undertake all servicing requirements for your appl...

Ce manuel est également adapté pour les modèles :
Ventilateurs - MCH 660 (692.4 kb)
Ventilateurs - MCH 660 (692.4 kb)
Ventilateurs - MCH 660 (692.4 kb)
Ventilateurs - MCH 660 (692.4 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories