Fabricant : Electrolux
Taille : 2.24 mb
Nom Fichier : 6872100en.pdf
|
Facilité d'utilisation
• Failure to observe these basic rules will drastically reduce the performance and increase the noise levels of the extractor hood. 77 Introduction Extractor version • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one activated carbon filter (special accessory). • You will need original AEG carbon filter for this function (see Special Accessories). • The air is discharged to the outside through a pipe, which must be fitted to connection flange A. Fig. 1. • In order to obtain the best performance the hose should have a diameter equal to the outlet hole. For the extractor version this pipe must have a diameter of 150 mm. Should there already be a pipe of diameter 125 mm that ducts to the outside through the walls or roof, it is possible to use the 150/ 125 mm reduction flange provided. In this case the hood will be slightly more noisy. Fig. 1 A Filter version • The air is filtered through an activated charcoal filter and returned to the kitchen through the top grill of the outlet pipe. • When the hood is used in the filter version it must be fitted with an original AEG KF20 activated charcoal filter (see Special accessories). • Fix the deflector using 4 screws O 3.5x6.5 mm. Fig. 2. FFig. 2 Hood Operation • Best results are obtained by using a low speed for normal conditions and high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared. The control switches are located on the unit’s front panel: A -Main switch, hood on/off. B -Start and choice of motor speed 1-2-3-1-2......... C -Indicates speed 1 (LED). D -Indicates speed 2 and saturation of the grease filter (LED) E -Indicates speed 3 and saturation of the activated charcoal filter (LED) (flashing LED) F -Indicates Intensive speed (LED). G -Intensive speed on/off. The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood revert to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will automaticly be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. H -Light OFF I -Light ON A B C D E F G H I Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. Control device for grease and activated charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the activated charcoal filter (in the case of recirculation version with activated charcoal filter). On delivery, the hood is not supplied with an activated charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with an activated charcoal filter, the saturation indicator light must be enabled as follows: Press buttons B and G si...
Ce manuel est également adapté pour les modèles :Ventilateurs - DI 8610 (2.24 mb)
Ventilateurs - DI 8610 (2.24 mb)
Ventilateurs - DI 8610 (2.24 mb)
Ventilateurs - DI 8610 (2.24 mb)