Évaluations - 5, GPA: 4.2
(
)
)
|
Facilité d'utilisation
Check with your car/truck dealer. Use only specified car battery cord. •To avoid blowing the car battery cord fuse, do step 2 in the proper order. • Running vehicles must be well ventilated. • When not in use, disconnect cigarette lighter plug. 11 Cassette Information Cassette Insertion/Removal 1 2 3 4 5 Turn Tape Wheel in direction of arrow until there is no slack. Attach Battery (page 9). Slide TAPE EJECT to open door. Insert cassette as shown. Press here to close door. Record/Playback Time Use tapes with the ivnsm mark in this unit. • To remove the cassette, slide the TAPE EJECT switch. Tape Speed Selector Position Cassette type TC-20 TC-30 TC-40 SP (Standard Play) 20 minutes 30 minutes 40 minutes SLP (Super Long Play) 1 hour 1 hour 30 minutes 2 hours TAPE SPEED Selector SLP playback may contain more picture noise. Erase Protection Tab A record tab ensures recordings are not accidentally erased. 1 2 To prevent erasure, break off tab with screwdriver. (Or, slide tab open.) To record again, cover hole with adhesive tape. (Or, slide tab closed.) 12 For assistance, call 1-800-211 -PANA(7262) Attaching Shoulder Strap Remove Battery Pack before doing steps. 1 Undo strap ends from buckles. Thread strap ends through Strap Rings on Camcorder. © minniiim min. 1 inch (25.4mm) Re-insert the strap ends into buckles. Adjusting the Length 1 Pull a loop of strap from buckle. Pull strap tight to shorten or lengthen. Hand Strap Adjust Hand Strap length to fit your hand as shown. 13 MENU Mode Using MENU Mode Before you begin... • Connect Camcorder to power source. • Set POWER to CAMERA. 1 2 3 Press MENU for MENU mode. --- MENU --- PAGE 1/2\ PROGRAMMED REC TITLE ; AUTO/MANUAL TALLY LAMP ; ON STAND-BY RELEASE ; OFF Mimaki SELECT SET END PUSH T/A KEY PUSH DISPLAY KEY PUSH MENU KEY , Press UP A or DOWN ▼ to highlight menu item. Press DISPLAY to set selection. Press MENU to exit. Note: • The Menu mode is canceled if UP/ DOWN(A/Y), DISPLAY, or MENU are not pressed within 5 minutes. MENU Mode Screen 1 2 3-4 4 5 - - - MENU - - - PAGE 1/2 ' PROGRAMMEDREC TITLE ; AUTO/MANUAL TALLY LAMP ; ON STAND-BY RELEASE ; OFF CLOCK SET SELECT SET END PUSH WAKEY PUSH DISPLAY KEY PUSH MENU KEY j X A PAGE 2/2 TIME LAPSE ; OFF SECURITY ; OFF VIDEO EFFECTS ; FADE BLACK SELECT SET Vend PUSH T/A KEY PUSH DISPLAY KEY PUSH MENU KEY j PROGRAMMED REC (page 23). Camcorder starts and stops recording at a preset time. TITLE (pages 39-41). AUTO/MANUAL : 16 items PHRASE : 10 items TALLY LAMP (page 32). ON: lamp tights during recording. STAND-BY RELEASE (page 21). ON: enables quick resumption of recording from Stand-by mode. CLOCK SET (pages 15-17). Select to set clock. TIME LAPSE (page 38). ON: enables TIME LAPSE recording. SECURITY (page 37). MOTION: enables Motion Security recording. VIDEO EFFECTS (pages 33, 34). AUTO FADE : BLACK or WHITE DIGITAL FADE : TYPE -► 7 types COLOR -♦ 8 colors 14 For assistance, call 1-800-211-PANA(7262) Setting the Clock Set the following items in order: Time Zone, Daylight Saving Time, Date and Time. Before you begin... Setting the Time Zone • Connect Camcorder to power source. • Set POWER to CAMERA. The Camcorder is preset to Eastern time. To change time zone, do steps at right. Time Zone chart Note:-:- • Setting POWER to VCR also displays CLOCK SET menu. • Clock may lose or gain up to 2 minutes per month. To adjust, see page 17. 1 Press MENU for MENU mode. Press UP A or DOWN ▼ to select CLOCK SET - - - MENU • - • PAGE 1« ' PROGRAMMEO HEC TITLE ; AUTO/MANUAL TALLY lamp ; ON STAND-BY RELEASE ; OFF SELECT SET END PUSH T/A KEY PUSH DISPLAY KEY PUSH MENU KEY Press DISPLAY for CLOCK SET menu. Press UP A or DOWN ▼ to select TIME ZONE CLOCK SET - - - HITI>7«I?T3 O. S. T. DATE / TIME ; EASTERN ; AUTO ; 12 : 00:00AM JAN t 1999 SELECT SET END PUSH T/A KEY PUSH DISPLAY KEY PUSH MENU KEY Press DISPLAY for SELECT TIME ZONE menu. Press UP A or DOWN T to select local time zone. - - - SELECT TIME ZONE ATLANTIC CENTRAL MOUNTAIN PACIFIC ALASKA HAWAII SAMOA SELECT: PUSH T/A KEY SET : PUSH DISPLAY KEY Press DISPLAY to confirm entry. Press MENU twice to exit. • When traveling, repeat these steps and select one of the 8 listed time zones to set the clock to local time. r Note:-;- When traveling outside the listed time zones, set clock to local time manually (page 17). 15 Setting the Clock Auto Daylight Saving Time Clock will auto-adjust to daylight-saving time (DST). Before you begin... • Connect Camcorder to power source. • Set POWER to CAMERA. -Note: - • When POWER is set to VCR. CLOCK SET menu appears. • Auto DST does not function if time zone is set to Hawaii or Samoa (page 15). The Camcorder is preset to DST: FJiiW. If DST is not observed in your area, set toMddbv doing the following steps. AUTO 1 Press MENU for MENU mode. Press UP A or DOWN ▼ to select CLOCK SET --- MENU - -- ...