Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
The heating process will commence after approx. 10 seconds, LED 5 switches off, LED 1, 2 and 3 will light again to indicate the temperature already achieved while LED 4 flashes to indicate that heating up continues. The set temperature is achieved as soon as all five LEDs light up. Example: Reduce set temperature The water temperature and the set temperature are approx. 75 °C, all five LEDs light up. The new desired temperature is approx. 45 °C. ¦ Press button 8 – once, only LED 5 lights and indicates the temperature currently set. ¦ Press button 8 – three times until LED 2 (approx. 45 °C) lights up. The new value becomes effective after approx. 10 seconds and heating is discontinued. The appliance cools down and the LEDs switch off over time until the set temperature is reached. LEDs 1 and 2 light up. Note: If the temperature drops, e.g. when water is used, the heating switches back on automatically. The LED flashes until the temperature is achieved. Tip Water loss and scaling are at their lowest at water temperature setting stage e (approx. 55 °C, LED 3). 8 GB GB ¦ If warm water is not required for an extended period, set the tank to frost protection mode with button 6 Only red LED 9 lights up. ¦ The tank must be drained fully by our customer service department or an authorised specialist in order to avoid frost damage, if the appliance is disconnected from the electrical supply. ¦ The device should be disconnected from the mains supply when working on the water supply. Error signals ¦ LEDs 9 and 2 flash Overheating protection has been activated. Call customer service. ¦ LEDs 9 and 3 flash The anode is spent and must be replaced. Customer service must be contacted as otherwise corrosion prevention is no longer guaranteed. The device can continue to be used for a very short time with the “heat once” function. ¦ LEDs 9 and 4 flash The temperature sensor is defective. Call customer service. Cleaning ¦ Clean externally with a mild cleaning agent. Do not use aggressive or abrasive detergents! Maintenance/Customer Service ¦ Repairs and other maintenance work may only be carried out by one of our authorized customer service representatives in order to avoid potential sources of danger. ¦ When you contact customer service, please quote the E and FD numbers on your appliance (Fig. A). ¦ The first inspection must be carried out no later than 2 years subsequent to initial startup of the appliance. This involves inspection of the protection anode which may need to be replaced, and the appliance may need to be cleaned and descaled. The customer service will suggest the next inspection date for a service. ¦ The power supply and the water supply must be shut off before all work on the appliance. Technical data Rated capacity [l] 30 50 80 100 Rated voltage [V] 220–240 (~ 50 Hz) Rated output DGxxx31E Rated output DGxxx31R Rated output DGxxx31P [W] 1500 2000 2000 Rated current DGxxx31E Rated current DGxxx31R Rated current DGxxx31P [A] 6.5 8.7 8.7 Fuse protection...
Ce manuel est également adapté pour les modèles :Chauffe-eau - DG10031P/01 (263.92 kb)
Chauffe-eau - DG10031R/01 (263.92 kb)
Chauffe-eau - DG30031E/01 (263.92 kb)
Chauffe-eau - DG30031P/01 (263.92 kb)