Évaluations - 2, GPA: 3
(
)
)
|
Facilité d'utilisation
Tune-up specifications Armature air gap is .010-.014 in. (.25-.36 mm) Spark plug gap is .030 in. (.76 mm) Valve clearance is: Intake* . . . . . . . . . . . . . . . . . . . . . . .003-.005 in. (.08-.13 mm) Exhaust* . . . . . . . . . . . . . . . . . . . . .005-.007 in. (.13-.18 mm) * with valve springs installed and piston 1/4 in. (6mm) past top dead center. In the USA and Canada, a 24 hour hot line, 1-800-233-3723, has a menu of pre-recorded messages offering you engine maintenance information. 9 Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB) and the United States Environmental Protection Agency (U.S. EPA) Emission Control System Warranty Statement (Owner’s Defect Warranty Rights and Obligations) In the interest of the environment, B&S engines that meet strict emis-TO CERTIFIED ENGINES PURCHASED IN CALIFORNIA IN 1995 sion requirements are labeled, “This engine conforms to 1995 - 1998 AND THEREAFTER, WHICH ARE USED IN CALIFORNIA, AND California emission regulations for ULGE engines and U.S. EPA TO CERTIFIED MODEL YEAR 1997 AND LATER ENGINES Phase I regulations for small non-road engines.” WHICH ARE PURCHASED AND USED ELSEWHERE IN THE EMISSION CONTROL WARRANTY COVERAGE IS APPLICABLE UNITED STATES. California and United States Emission Control Defects Warranty Statement CARB, U.S. EPA and B&S are pleased to explain the Emission Control System Warranty on your 1996 and later utility or lawn and garden equipment (ULGE) engine. In California, new ULGE engines produced on or after August 1, 1995 must be designed, built and equipped to meet the State’s stringent anti-smog standards. Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later, must meet similar standards set forth by the U.S. EPA. B&S must warrant the emission control system on your engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your ULGE engine. Your emission control system includes parts such as the carburetor, air cleaner, ignition system, muffler and catalytic converter. Also included may be connectors and other emission related assemblies. Where a warrantable condition exists, B&S will repair your ULGE engine at no cost to you including diagnosis, parts and labor. Briggs & Stratton Emission Control Defects Warranty Coverage ULGE engines are warranted relative to emission control parts de-any covered part on your engine is defective, the part will be repaired fects for a period of two years, subject to provisions set forth below. If or replaced by B&S. Owner’s Warranty Responsibilities As the ULGE engine owner, you are responsible for the performance You are responsible for presenting your ULGE engine to an Authoof the required maintenance listed in your Operator/Owner Manual. rized B&S Service Dealer as soon as a problem exists. The undis- B&S recommends that you retain all your receipts covering mainte-puted warranty repairs should be completed in a reasonable amount nance on your ULGE engine, but B&S cannot deny warranty solely of time, not to exceed 30 days. for the lack of receipts or for your failure to ensure the performance of If you have any questions regarding your warranty rights and re- all scheduled maintenance. sponsibilities, you should contact a B&S Service Representative at As the ULGE engine owner, you should however be aware that B&S 1-414-259-5262. may deny you warranty coverage if your ULGE engine or a part has The emission warranty is a defects warranty. Defects are judged on failed due to abuse, neglect, improper maintenance or unapproved normal engine performance. The warranty is not related to an in-use modifications. emission test. Briggs & Stratton Emission Control Defects Warranty Provisions The following are specific provisions relative to your Emission Control Defects Warranty Coverage. It is in addition to the B&S engine warranty for non-regulated engines found in the Operator/Owner Manual. 1. Warranted Parts Coverage under this warranty extends only to the parts listed below (the emission control systems parts) to the extent these parts were present on the engine purchased. a. Fuel Metering System • Cold start enrichment system (soft choke) • Carburetor and internal parts • Fuel Pump b. Air Induction System • Air cleaner • Intake manifold c. Ignition System • Spark plug(s) • Magneto ignition system d. Catalys...
Ce manuel est également adapté pour les modèles :Air - 28N700 (477.38 kb)
Air - 310700 (477.38 kb)
Air - 311700 (477.38 kb)
Air - 312700 (477.38 kb)