Évaluations - 1, GPA: 5
(
)
)
|
Facilité d'utilisation
Remove excess water without damaging the filter, remove the plastic parts, and let the mat dry in the oven for at least 15 minutes approximately at a maximum temperature of 100°C. To keep the regenerable charcoal filter functioning efficient this operation must be repeated every 2 months. These must be replaced at least every 3 years or when the mat is damaged. • Before remounting the anti-grease filters and the regenerable active charcoal filters it is important that they are completely dry. • Clean the hood frequently, both internally and externally, using a cloth dampened with denatured alcohol or neutral liquid detergents that are non abrasive. • The lighting .system is designed for use during cooking and not for the prolonged general lighting of the room. The prolonged use of the lighting system significantly decreases the average duration of the bulbs. • If the appliance is equipped with courtesy lights it is possible to use them for general room lighting for a prolonged amount of time. • Attention: the non compliance with the hood cleaning warnings and with the replacement and cleaning of the filters entails risk of fires. One therefore recommends keeping to the suggested instructions. • Replacing halogen light bulbs (Fig.8): In order to replace the dichroic lamps, carefully remove the lamp from the lamp holder with the help of a small flat screwdriver or a similar tool. PLEASE NOTE! In doing this operation, please take care not to scratch the hood. Replace the bulbs with new ones of the same type. • Replacing halogen light bulbs (Fig.9): To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. Replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands. • Replacing LED lamps (Fig.10): If the appliance version is with LED lamps, the intervention of a specialised technician is necessary to replace them. • Replacing the halogen/incandescent lamps (Fig.11): Only use lamps of the same type and Wattage installed on the device. • Commands luminous (Fig.12.A.B.) the key symbols are explained below: A = LIGHT B = OFF C = SPEED I D = SPEED II E = SPEED III F = AUTOMATIC STOP TIMER - 15 minutes (*) If your appliance has the INTENSIVE speed function, from speed THREE, press key E for 2 seconds and it will be activated for 10 minutes after which it will return to the previously set speed. When the function is active the LED flashes. To interrupt it before the 10 minutes have elapsed, press key E again. Some models allow activating this function even with speed one and two. By pressing key F for two seconds (with the hood switched off) the “clean air” function is activated. This function switches the appliance on for ten minutes every hour at the first speed. As soon as this function is activated the motor starts up at the first speed for ten minutes. During this time key F and key C must flash at the same time. After ten minutes the motor switches off and the ...
Ce manuel est également adapté pour les modèles :Hoods - KD-TG60 Glass (968.45 kb)
Hoods - KD-P90AL (968.45 kb)
Hoods - KD-PR60X (968.45 kb)
Hoods - KD-PL60X (968.45 kb)