Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
• Ensure that the wall plugs are secure. Max. weight in kg: 50 Design subject to modification in line with technical development. Installing the upper support frame 1. Specify the total height of the support frame before installation and mark the screw holes. The height of the support frame can be adjusted in 20 mm steps. The total height is measured from the height of the ceiling, the height of the worktop and the corresponding distances between the hob and extractor hood. 2. On the ceiling mark the centre point of the extractor hood. 3. Using the enclosed template, mark the positions for the screws on the ceiling. 4. Drill 4x 8 O mm holes and press in wall plugs flush with the ceiling. 5. Attach the upper part of the support frame to the ceiling with 4 screws. 6. Ensure that the support frame is in the correct position. The middle bracket defines the preferred side. It must be facing the hob control. 31 Installation Installing the lower support frame Attach upper and lower parts of the support frame at the specified total height with 10 screws (preferred hole selection, see diagram). Ensure that the lower support frame is in the correct position. The open side must be facing the hob control. NOTE: The support frame can be aligned subsequently by loosening the fastening screws on the ceiling. Installing the extractor hood 1. Hook the extractor hood from below into the support frame. Do not trap the power cord! 2. Attach the extractor hood to the support frame with 2 securing screws. 3. Hook in retaining clip and screw tight. 4. Connect the pipes. 5. Connect the power supply. Exhaust-air mode 700-880 Circulating-air mode 700-1000 Installation Installing the flue ducts 4. Push up the upper flue part and secure with 2 screws. RISK OF INJURY The insides of the flue ducts may have sharp edges. We recommend wearing protective gloves during installation. 1. Separate the flue ducts.To do this, remove the adhesive tape. 2. Remove the protective film from both flue ducts. 3. Attach both parts of the upper flue to the extractor hood und push together. NOTE: Protect the extractor hood from damage. Avoid scratching the sensitive surfaces. 5. Insert the two lower parts of the flue and push together. Tabel de matieres Informations generales ....................................................................................... 34 Conseils pour le respect de l’environnement ....................................................................................34 Avant la premiere utilisation......................................................................................................................... 34 Consignes de securite ......................................................................................... 35 Conformite d’utilisation .................................................................................................................................. 35 Securite technique ............................................................................................................................................35 Consignes speciales pour les appareils de cuisson au gaz .......................................................36 Utilisation correcte .............................................................................................................................................37 Montage correct ..................................................................................................................................................37 Modes de service ................................................................................................. 38 Mode Evacuation de l’air ................................................................................................................................38 Mode Recyclage de l’air ..................................................................................................................................38 Utilisation .............................................................................................................. 39 Nettoyage et entretien ....................................................................................... 40 Depose et incorporation des filtres a graisse ................................................. 41 Depose et incorporation des filtres a graisse ....................................................................................41 Depose et incorporation des filtres au charbon actif ..................................................................41 Remplacement des ampoules ........................................................................... 42 Consignes de montage ....................................................................................... 43 Jonction des conduits .....................................................................................................................................43 Branchement electrique .....................................................
Ce manuel est également adapté pour les modèles :Hoods - DIA093450V/02 (3.14 mb)
Hoods - DIA093650/01 (3.14 mb)
Hoods - DIA093650/02 (3.14 mb)