Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
As a result, the appliance may corrode. • Do not place any objects on the extractor hood. RISK OF FIRE Do not flambe under the extractor hood or work with a naked flame. When switched on, the extractor hood draws flames into the filter. There is a risk of fire due to deposits on the grease filter! • Do not leave pans, frying pans or deep-fat fryers unattended if you are cooking food with oils or fats, e.g. chips. Overheated oils or fats can easily ignite! • A risk of fire can be prevented by cleaning the grease filters regularly and changing the activated-carbon filter in good time. • Never operate the extractor hood without grease filters. Correct installation • Check the manufacturer’s specifications for the cooker to determine whether an extractor hood can be operated over it. • If the manufacturer of the cooker has not specified any significant safety distances, the following minimum distances apply – 550 mmbetween electric hob and the lower edge of the extractor hood – 650 mmbetween gas hob (upper edge of pan support) and the lower edge of the extractor hood, (see fig. 1, page 2). • If various cookers are used, the greatest indicated distance applies. • The width of the extractor hood must correspond to the width of the cooking area. • The extractor hood must not be installed over a solid fuel heating appliance which may be a fire risk (e.g. flying sparks) unless the heating appliance has a closed, non- detachable cover and the country-specific regulations are observed.This restriction does not apply to gas cookers and gas hobs. • To avoid damaging the hob, cover it when installing the extractor hood. Operating modes • The extractor hood can be used in exhaust air and circulating air mode. The standard setting is exhaust air mode. Exhaust-air mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Appliance dimensions Exhaust air Circulating-air mode The air which is drawn in is cleaned by the grease filters andan activated carbon filter and conveyed back into the kitchen. An activated carbon filter must be installed to bind odours in circulating-air mode (see ”Removing and installing the grease filters”). The complete installation set as well as the replacement filters are available from specialist outlets, customer service or the Online Shop. The accessory number can be found at the end of the operating instructions. Appliance dimensions Circulating air Switching the electronic control to circulating air mode • The extractor hood must be connected and switched off. • Simultaneously press buttonsN andr untilais displayed. • Repeatedly press buttonsN andr to switch the electronic control back to exhaust air mode by (display#). Operation Grease filter saturation display Display fan settings Fan run-on Light Fan On/Off Switch back fan Switch on and increase fan Intensive setting NOTE:It is recommended to switch on the blower when you start co...
Ce manuel est également adapté pour les modèles :Hoods - I72F57N0/01 (2.43 mb)
Hoods - I72F57N0/02 (2.43 mb)