Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
2. Draw a line on the wall from the ceiling to the lower edge of the hood at the centre of the location where the hood is going to be mounted. 3. Using the template, mark positions on the wall for the screws. Ensure that the minimum distance between the hob and the extractor hood is maintained – 550 mm for an electric hob and 650 mm for a gas hob. The bottom edge of the template equates to the lower edge of the extractor hood. 4. Drill 5 holes (dia. 8 mm) for the extractor hood and 4 holes (dia. 8 mm) for the brackets for fixing the flue ducts and insert wall plugs flush with the wall. Note: Take into account any special accessories that are going to be fitted. 5. Screw on the 2 brackets for fixing the upper and lower flue ducts. 6. In order to help fix the hood onto the wall, screw in the middle screw (without a washer) until it protrudes by approx. 5 mm. 7. Hook the extractor hood over the screw in the wall 228 228 27 465 220 400 68 113 39 mind. 550 Elektro 650 Gas 5 ca. 5mm 26 Installation 08. Insert the other 4 screws with washers. Before the 4 screws are tightened down, align the extractor hood properly. 09. Connect up the air outlet pipe. 10. Connect the hood to the electricity supply. 11. Stainless steel model: . Remove the protective film from the two flue ducts. Avoid damage to the sensitive surface. Warning: The interior walls of the flue panelling can have sharp edges – Risk of injury –. We recommend that you wear gloves when installing. 13. Position the lower flue duct on the extractor hood and screw the extractor hood to the flue duct from below with 2 long screws. To prevent scratching the upper duct when pushing on the lower duct, cover the edge of the lower duct with the installation template or other protective material. Then screw the flue duct to the sides of the fixing bracket with 2 short screws. Before tightening the 2 screws, align the flue duct. 14. Re-insert the grease filter (see operating instructions). 1. 2. 12. Screw the upper flue duct to the sides of the fixing bracket with 2 short screws. Mode d’emploi Description de l'appareil Commutateur Lumiere/Ventilateur Capot de cheminee Grille du filtre Eclairage Modes de fonctionnement Air evacue a l'exterieur: . Le ventilateur de la hotte aspire les buees de cuisson qui traversent un filtre a graisse avant de regagner l'atmosphere exterieure. . Ce filtre retient les particules grasses solides en suspension dans les buees de cuisson. . Les particules grasses ne se deposent plus dans la cuisine, les odeurs de cuisson disparaissent. D Si la hotte evacue l'air a l'exterieur et si le logement comporte des moyens de chauffage (tels par ex. des appareils de chauffage au gaz, au fuel ou au charbon, chauffe-eau instantanes ou a accumulation) raccordes a une cheminee, veiller imperativement a ce que l'apport d'air soit suffisant pour assurer la marche du chauffage a combustion. Un fonctionnement sans risque est possible si la depression dans le local ou le foyer de chauffage est imp...
Ce manuel est également adapté pour les modèles :Hoods - LC653WA10/01 (3.86 mb)
Hoods - LC654WA10/01 (3.86 mb)
Hoods - LC654WA20/01 (3.86 mb)
Hoods - LC657WA20/01 (3.86 mb)