Évaluations - 3, GPA: 3.3 ( )

Fabricant : Carrier Taille : 241.09 kb Nom Fichier : 35a60d48-98fc-ef74-31e2-06470e29e101.pdf Langue d'enseignement:

Warning! When changing the side at which the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand. Tilt the appliance slightly towards the + rear and prop it securely. Unscrew the door hinge screws (K) + and remove the hinge pin bracket (1). Open the door a little way and take it + out downwards. Unscrew the upper pin (A) and screw + it into place on the opposite side. Fit the door into the upper pin (A) + and close it. Screw the hinge pin bracket (1) + securely into place on the opposite side using the screws (K). Unscrew the handle. Refit it on the + opposite side after having pushed in the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. K 1 A 12 Changing over the freezer compartment door Open the freezer compartment door a little way. + Using a small screwdriver, press the spring + in the opening of the lower door bearing slightly upwards and take the door bearing out complete with the door. Position the covering cap (M) on + the opposite side. Turn the freezer compartment door + through 180° and fit the lower door bearing into the lower bearing cavity of the freezer compartment door. Lift the freezer compartment door + a little way upwards, fit it into the upper door bearing, and at the same time insert the lower door bearing into the square hole. Small upwards and downwards adjustments of the freezer compartment door will make fitting easier. Prior to Initial Start–Up Please clean the appliance interior and all accessories prior to initial + start-up (see section: “Cleaning and Care”). M 07 GREEN & YELLOW 13 AMP. FUSE BROWN CORD CLAMP BLUE 13 AMP GREEN & YELLOW 13 AMP. FUSE BROWN CORD CLAMP BLUE 13 AMP Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left. The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Important The wires in the mains lead are coloured in accordance with the following code: Green and Yellow: Earth Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1.The wire coloured green and yellow must be connected to the terminal marked with the letter “E” or by the earth symbol or coloured green and yellow. 2.The wire coloured blue must be connected to the terminal “N” or coloured black. 3.The wire coloured brown must be connected to the terminal marked “L” or coloured red. 4.Upon completion there must be no cut, or stray strands of wire pre sent and the cord clamp must be secure over the outer sheath. Warning! A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safely. Plug socket The plug socket necessary for connection of your appliance to the electricity supply should be positioned so that it is possible to pull out the appliance plug. If your appliance is installed under a continuous worktop, the plug sockettrip or similar with a minimum contact separation of 3 mm). 130 300 should be provided as shown. Alternatively a concealed spur socket fitted with a 13 A fuse may be fitted. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e.g. fuse, cut-out, current Description of the Appliance View of the appliance A Butter/cheese compartments with flap and egg storage insert A Door storage compartment with retaining rail (not for all models) A Door storage compartment A Bottle shelf A Vegetable drawers A Storage shelves . Temperature regulator and light switch C Freezer compartment E Rating plate A A C A A A A E . Starting up and temperature regulation Insert the plug of the connection lead into the plug socket with pro + tective earth contact. When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the right hand side of the refrigerator compartment. Setting “0” means: Off. Turning clockwise in direction “1”: Refrigerating unit on and the refrigerator operates automatically. Setting “1” means: Hightest temperature, warmest setting. Setting “6” (end-stop) means: Lowest temperature, coldest setting. The temperatures in the refrigerator compartment and freezer compartment cannot be independently regulated. At a low ambient temperature of around 16°C, setting “1” should be selected. At ambient temperatures of around...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :