Évaluations - 2, GPA: 3
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
DOORS The refrigerator doors have a special door opening and closing feature to make sure that the doors close all the way and are securely sealed. When opening the door, it will only open so far. After reaching a certain point, it will remain open. When the door is partially open, it will close automatically. The freezer light is located in the bottom of the auger motor case. INSTALLATION OF THE REFRIGERATOR Check the dimensions of your entrance door to determine whether the refrigerator can pass through it. • Select a location with easy access to the water supply. • Select a location with enough space for the refrigerator. • Select a location without direct exposure to sunlight. • Before disassembling the freezer door, the water supply line needs to be disconnected. (If not, the water supply line can be damaged.) • See “Separating the water supply line from the refrigerator” on the next page. Dimension (inch) Width Capacity (Cu. Ft) Model RS2544 RS2622/2644/2666 RS2777 26.1 without Hinge Case Height with Hinge with door Depth without door 36 69 70 35 30 27.2 36 69 70 37 30 25.2 36 69 70 35 28 Checking the Dimensions of your Entrance Door Selecting the Location for the Refrigerator Allow clearance to the right, left, back and top when installing the refrigerator. This has the advantage of reducing power consumption. Allow sufficient space to circulate the air at the internal cooling system. • When refrigerator has not enough space, the internal cooling system may not work correctly. NOTE 1 inch 0.1 inch 1 inch NOTE REMOVING THE REFRIGERATOR DOORS 1) Remove the screw from clamp ( ). 2) Remove the water tube by pressing the coupler (.) and pulling the water tube (.) away. Open the freezer and refrigerator doors, and then take off the front leg cover by turning the three screws counter-clockwise. a a FRONT LEG COVER SCREW Removing the Front Leg Cover Separating the Water Supply Line from the Refrigerator Do not cut the water tube but separate it from the coupler. NOTE REMOVING THE REFRIGERATOR DOORS 1) With the door closed, remove the upper hinge cover (.) using a screwdriver, and then disconnect the wires (.). 2) Remove hinge screws (.) and ground screw (.) counter-clockwise, and take off the upper hinge (.) along the arrow (.). Take care when removing the door to ensure that it does not fall on you. 3) Remove the door from the lower hinge (.) by carefully lifting the door (.). 4) Remove the lower hinge (.) from the bracket lower hinge (.) by lifting the lower hinge (.) in the direction of the arrow. Removing the Freezer Door • Lift the door straight up. • Be careful not to pinch the water tubing and wire harness on the door. • Place doors on a protected surface. NOTE REMOVING THE REFRIGERATOR DOORS 3) Remove the door from the lower hinge (.) by lifting the door (.). 4) Remove the lower hinge (.) from the bracket lower hinge (.) by lifting the lower hinge (.) in the direction of the arrow. 1) With the door closed, remove the upper hinge cover (.) ...
Ce manuel est également adapté pour les modèles :Réfrigérateurs - 24KLDW (2.07 mb)
Réfrigérateurs - RS21FANS (2.07 mb)
Réfrigérateurs - RS24DAMS (2.07 mb)
Réfrigérateurs - RS24DANS (2.07 mb)