Évaluations - 4, GPA: 4.3
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
- Shut off the main water supply line and turn the Ice maker to the off position. - Locate the nearest cold drinking water line. - Follow the instructions in the ice maker installation kit. 3.Copper (or Plastic) line 4.Compression Nut 5.Compression Sleeve 6.Shut Off Valve 7.Packing Nut. Connect the water line to the refrigerator Compression Nut - Slip the compression nut and plastic ferrule through the plastic tube. - After inserting the sleeve, tighten the compression nut onto 1/4” compression fitting(union). NOTE Do not overtighten the compression nut. - Slip the compression ferrule and nut on copper (or plastic) tubing as shown. Tighten the comperssion nut onto the compression fitting(union). -Turn water on and check for any leakege. NOTE Waterline must be connected to drinkable water only (Case 2) Check the water supply line Connect the water pipe with coupler and tap. - Close the main water tap. -Connect coupler “A” to the tap. Ferrule Sleeve Compression fitting Ferrule Compression Nut The water line must be connected to the cold water pipe. If it is connected to the hot CAUTION water pipe, it may cause the purifier to malfunction. - Every join should be protected with sealing tape. WARRANTY INFORMATION This water line installation is not covered by the refriger- ator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage. COUPLER “A” Note: If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase TAP the right couplers fittings. 28 INSTALLING THE WATER DISPENSER LINE COMPRESSOR COVER OF REFRIGERATOR - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. - When connected, check if there is any leakage. If any, repeat the connection. - Reattach the compressor cover of the refrigerator. CONNECTION NUT WATER LINE CLIP A WATER LINE - Using clip ”A”, fix the water line to the wallor (the back of refrigerator). - When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed. Complete the installation of the water supply line. - Power on the refrigerator and press the lever on the right of the dispenser until water runs out through the water line and all air has been empty. - At this time, check for any possible leakages at the join point in the water line. After securing the water line, move the refrigerator to the required location. Once the refrigerator is in position, do not move possibly. Install the water filter. Connect the water line to the refrigerator. Secure the water line. -As shown, separate the fixed cap in the refrigerator by rotating it counterclockwise. Remove the water filter from the box and put a month indicator sticker on the filter as shown. - Write the month you installed the filter on the label. EX) If the water filter was installed in March, put “MAR” -Remove the protective cap then position and insert the filte...
Ce manuel est également adapté pour les modèles :Réfrigérateurs - 24KLDW (2.81 mb)
Réfrigérateurs - RS21FANS (2.81 mb)
Réfrigérateurs - RS24DAMS (2.81 mb)
Réfrigérateurs - RS24DANS (2.81 mb)