|
Facilité d'utilisation
To replace : When replacing the drawer, be sure to press it ICE MAKER firmly into place. If it does not go all the way back, remove it and rotate the drive mechanism 1/4 turn. Then push the drawer back again. 2) Throw away the first few batches of ice to allow the water line to clear. Be sure nothing interferes with the sweep of the feeler arm. When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together. If ice is not used frequently, old ice cubes CHECK THE WATER LEVEL will become cloudy, taste stale and shrink. Rotate 3) Important Facts About Your Dispenser : Do not add ice from trays or bags to the storage bin. It may not crush or dispense well. Avoid overfilling glass with ice and use of Drive Mechanism narrow or extra-tall glasses. Backed-up ice can jam the chute or cause the door in the chute to freeze shut. If ice is blocking the chute, poke it through with a wooden spoon. Beverages and foods should not be quick-chilled in the ice storage bin. To keep dispensed ice from missing the glass, put the glass close to, but not touching, the dispenser opening. Some crushed ice may be dispensed even though you selected CUBES. This happens occasionally when a few cubes accidentally get directed to the crusher. After crushed ice is dispensed, some water may drip from the chute. 4) Water Supply to the Icemaker : The icemaker must be connected to a cold water line. 5) Start the Icemaker : Set the "Ice Type" to the "Cubed Ice" or "Crushed Ice" position. The icemaker will not begin to operate until it reachs its operating of 10.4°F( -12°C) or below. It will then begin operation automatically if the "Ice Type" is in the "Cubed Ice" or "Crushed Ice" position. Feeler Arm • If there is no water supply, turn off the icemaker to save energy. • In lower water pressure conditions, the water valve may turn on up to 3 times to make sure enough water reaches the icemaker. NOTE 33 INSTALLATION INSTRUCTIONS BEFORE YOU CALL FOR SERVICE... Problem The refrigerator does not work sufficiently or at all The food in the refrigerator is frozen Unusual noises or sounds are heard Possible Causes • Disconnected power plug • Is the temperature control on the display panel set to the correct temperature? • Is the refrigerator in direct sunlight or located near a heat source? • Is the back of the refrigerator too close to the wall? • Is the temperature control on the display panel set to the correct temperature? • Is the temperature in the room too low? • Did you store the food with a high water content in the coldest part of the refrigerator. • Is the back of the refrigerator too near to the wall? • Was anything dropped behind or under the refrigerator? What To Do • Check that the power plug is properly connected. • Try setting it to a lower temperature. • Move the refrigerator to the proper location. • Try setting it to a warmer temperature. • Check that the floor is levelled and stable. • Move the refrigerator to the proper location. • Remove the foreign thing. • A “ticking” sound may be heard from inside the refrigerator. This is normal and occurs because various accessories contract or expand. • HOT-PIPE is installed in the front cor-• Normal state The front corners and ners of refrigerator. That makes refriger sides of the cabinet are ator’s temperature low quickly and save hot; condensation occurs the power consumption. • Condensation can occur when you leave • Normal state the door open for a long time. • Did you stop the ice making function? • See the control panel. Ice is not dispensed • Is there any ice in the storage unit? • See the ice container. • Is the water pipe connected and the • See the valve. shut-off valve open? • Is the freezer temperature too warm? • Set the temperature lower. • Did you wait for 12 hours after installation of the water supply line before making ice? • The bubbling comes from the refrigera-• Normal state You can hear water bub bling in the refrigerator nt circulating in the refrigerat...
Ce manuel est également adapté pour les modèles :Réfrigérateurs - RS2611SW (2.57 mb)
Réfrigérateurs - RS2621BB (2.57 mb)
Réfrigérateurs - RS2621RS (2.57 mb)
Réfrigérateurs - RS2621SH (2.57 mb)