Évaluations - 1, GPA: 3
(
)
)
|
Facilité d'utilisation
Opening or closing the door may cause feet or hands to be caught in the chink in door or the child to be get hurt by the corner. Do not put any living animal in the refrigerator. 11 Introduction Identification of parts • Parts, features, and options vary by model. Your model may not include every option. NOTE Freezer Compartment Refrigerator Compartment Milk product corner LED Lamp Automatic Icemaker Shelf Shelf Shelf Door rack Drawer(2) Door rack Lower cover Shelf Can Server Refreshment center Nano charcoal deodorizer Egg Box LED Lamp Filter (Optional) Door Rack Door Rack Door Rack Fresh compartment Fresh compartment Vacuum fresh compartment Because opening or closing the door or the home bar of the refrigerator may cause injury to the person around it, be careful, please. Opening or closing the door may cause feet or hands to be caught in the chink in door or the child to be get hurt by the corner. Do not put any living animal in the refrigerator. Installation Installation Select a good location Disposal of the old appliance Where to Install 1. Place your appliance where it is easy to use. 2. Avoid placing the unit near heat sources, direct sunlight or moisture. 3. To ensure proper air circulation around the fridge -freezer, please maintain sufficient space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall. 4. To avoid vibrations, the appliance must be leveled. 5. Don't install the appliance below 5.C. It may cause affect the performance. This appliance contains fluid (refrigerant, lubricant)and is made of parts and materials which are reusable and/or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For take back, please contact with the local agency. 12 Installation Installation WARNING Remove lower cover and then feed water tube Remove the freezer compartment door Remove the refrigerator door Door removal Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Remove the lower cover by lifting upward and then pull up the feed water tube while pressing area • shown in the figure to the right. Lower cover Feed water tube NOTE • If a tube end is deformed or abraded, cut the part away. 1) Removing the hinge cover by loosening the screws. Separate all connection wires except for the earth line after. Upper hinge Ground Line Upper hinge 2) Remove the keeper by rotating it counter Keeper clockwise () and then lifting the upper hinge up (). Connection wires Hinge cover NOTE • When removing the upper hinge, be careful that the door does not fall forwards . 3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out. Lower hinge NOTE • Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube. 1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the earth line. Connection wires Upper hinge Keeper 2) Remove keeper by rotating it clockwise () and then remove the upper hinge by lifting it up (• ). 3) Remove the refrigerator compartment door by lifting it up. Lower hinge 13 14 Installation Door replacement Feed water pipe installation Pass the refrigerator laterally through the access door as shown in the right figure. Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.). If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed. Keep the total length of the feed water pipe tube within 8m and be careful for the tube not be bent. If the tube is 8m or longer it may cause trouble in water feed owing to the drain water pressure. Install the feed water pipe tube at a place free from heat. Connect to potable water supply only. Refer to instructions with water filter kit for installation. Mount them in the reverse sequence of removal after they pass through the access door. Pass the refrigerator Before installation 12345Max FRZ TEMP REF TEMP Min54321 Max WARNING Installation Installation When the floor is not leveled When the fridge door is lower than the freezer door CAUTION After leveling the door height Next Height adjustment -When the height of the door may not be Height difference leveled when the floor is not leveled. When the freezer door is lower – Use the (-) driver or spanner to turn the groove or nut of the height adjustment screw on the left to the counterclockwise direction to level the door. When the f...
Ce manuel est également adapté pour les modèles :Réfrigérateurs - GR-P247JYLW (1.64 mb)