Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
If installation next to a heat source is unavoidable, use a suitable insulating plate or maintain the following minimum distances from the heat source: n 3cm from an electric or gas cooker, n 30cm from oil or solid fuel cookers. If the appliance is being installed next to another refrigerator or freezer, maintain a minimum distance between the sides of the two appliances of 25mm. This prevents the formation of condensation. If there is a cover or cupboard above the appliance, there must be a gap of 10mm to enable the appliance to be pulled out if necessary. The heated air must be able to escape unimpeded from the rear of the appliance. If the appliance is being installed in the corner of a room or in a niche, the minimum required gaps (see section "Device and installation dimensions") at the sides of the appliance must be observed so that the doors can be opened all the way. If adjacent kitchen units are deeper than 75 cm, the minimum required gaps at the side must be observed in order to enable the entire door opening angle to be used (see section "Door opening angle"). Floor surface Inform ation! The appliance is very heavy. The floor at the installation location must not sag. If necessary, reinforce it. Empty weight: Basic model 147kg en en Note the ambient temperature and ventilation The climate class is stated on the nameplate. It specifies the room temperatures suitable for using the appliance. The nameplate is on the right of the appliance. Climate class Permissible ambient temperature SN +10 °C to 32 °C N +16 °C to 32 °C ST +16 °C to 38 °C T +16 °C to 43 °C Ventilation The air from the base panel at the front and cover plate at the rear heats up. The heated air must be able to escape unimpeded. Otherwise, the refrigerating unit has to work harder, which increases the appliance’s power consumption. You must therefore never cover or block the ventilation openings. Installing and connecting up the appliance n The appliance must be installed and connected up by a specialist in accordance with these assembly instructions. n Once the appliance has been positioned, wait at least 8hours before plugging in the mains cable. The oil in the compressor can shift to the refrigeration system during transport. n Before starting the appliance up for the first time, clean its interior (see section Cleaning the appliance"). n The water line must be connected up before the electrical connections. n In addition to the statutory national regulations, the connection requirements of the local electricity and water supply companies are to be observed. n Only remove the transport locks on the trays and racks once the appliance has been installed. n If the appliance doors need to be removed in order for the appliance to fit through the doors of the house or flat, the doors must be removed by customer services only. Water connection ! War ning! Risk of electric shock and of damage to property! Disconnect the appliance from the elec...
Ce manuel est également adapté pour les modèles :Réfrigérateurs - KFN91PJ10A/02 (5.86 mb)
Réfrigérateurs - KFN91PJ10A/03 (5.86 mb)
Réfrigérateurs - KFN91PJ10N/01 (5.86 mb)
Réfrigérateurs - KFN91PJ10N/02 (5.86 mb)