AVERTISSEMENT / ATTENTION Ne jamais enlever plus de trois maillons d’une chaine. Cela pourrait endommager la roulette. TENSION DE LA SIERRA: Revise la tension frecuentemente y ajustela tan pronto como se necesite para mantener la cadena ajustada a la barra, pero lo suficientemente suelta para ser jalada con la mano. (Vea la seccion 3-5, Ajuste de la Tension de la Cadena de la Sierra.) ACONDICIONAMIENTO EN UNA CADENA PARA SIERRA NUEVA: Una barra y cadena nueva requeriran un reajuste despues de ta

Do not let the nose of the guide bar contact a log, branch, fence, or any other obstruction that could be hit while you are operating the saw. • Always cut with the engine running at full speed. Fully squeeze the throttle trigger and maintain a steady cutting speed. • Use only the correct original equipment manufacturer replacement bars, chains and other parts and accessories. These are available from your authorized service dealer. Use of any unauthorized parts or accessories could lead to seri

No grounding means is provided on a double insulated appliance, nor should a means for grounding be added to the appliance. No serviceable parts are inside. A double insulated appliance is marked with the words, “DOUBLE INSULATION” or “DOUBLE INSULATED”. The symbol (square within a square) may also be marked on the appliance. 1. Place switch in OFF position and unplug the power supply before the appliance is serviced, cleaned, or maintenance is performed. 2. Keep the air intake clean and air ven

Failure to lubricate the guide bar sprocket tip as explained below will result in poor performance and seizure, voiding the manufacturer’s warranty. Lubrication of the sprocket tip is recommended after each saw use. Always thoroughly clean guide bar sprocket tip before lubrication. The Lube Gun (optional) is recommended for applying grease to the guide bar sprocket tip. The Lube Gun is equipped with a needle nose tip which is necessary for the efficient application of grease to the sprocket tip.

SYMBOL MEANING • SAFETY ALERT SYMBOL Indicates danger, warning, or caution. May be used in conjunction with other symbols or pictographs. • WARNING - READ OPERATOR'S MANUAL Read the Operator’s Manual(s) and follow all warnings and safety instructions. Failure to do so can result in serious injury to the operator and/or bystanders. • WEAR EYE, HEARING AND HARDHAT PROTECTION WARNING: Thrown objects and loud noise can cause severe eye injury and hearing loss. Wear eye protection meeting ANSI Z87.1-

(See Section 3-5, Saw Chain Tension Adjustment). BREAKING IN A NEW SAW CHAIN A new chain and bar will need readjustment after as few as 5 cuts. This is normal during the break-in period, and the interval between future adjustments will begin to lengthen quickly. Over a period of time, however, the moving parts of the saw chain will become worn, resulting in what is called CHAIN STRETCH. This is normal. When it is no longer possible to obtain correct chain tension adjustment, a link will have to

30). 4. Remove spark plug with spark plug socket wrench. DO NOT USE ANY OTHER TOOL. Do not sand blast, WARNING: scrape or clean electrodes. Grit in the engine could damage the cylinder. 5. Check electtrode gaps with wire feeler gauge and set gaps to .025” (.635mm) if necessary. 6. Reinstall a new spark plug. NOTE: A resistor spark plug must be used for replacement (part no. 9295-310502). NOTE: This spark ignition system meets all requirements of the Canadian Interferen-Causing Equipment Regulati