Évaluations - 3, GPA: 4.7 ( )

Fabricant : Invacare Taille : 177.25 kb Nom Fichier : Langue d'enseignement:

1. Loosen, but DO NOT, remove the two (2) flat screws, washers and locknuts that secure contracture footplate to the footplate hinge. 2. Tilt the contracture footplate UP/DOWN to achieve desired angle. 3. Retighten the two (2) flat screws, washers and locknuts that secures the contracture foot plate to the footplate hinge. 4. If necessary repeat STEPS 1-3 on remaining contracture footplate. Contracture Assembly Footplate Hinge only. FIGURE 6 - ANGLE ADJUSTMENT OF THE CONTRACTURE FOOTPLATE Contracture Footplate Flat Screws NOTE: Mounting hardware shown removed for clarity Washers Lock Nuts 3 CONTRACTURE FOOTPLATE DEPTH ADJUSTMENT (FIGURE 7) NOTE: Refer to the GENERAL WARNINGS and INSTALLATION WARNINGS in theSAFETY SUMMARYof this instructionsheet. NOTE: Observe the angle of the contracture footplate for reinstallation. 1. Remove the two (2) flat screws, washers and locknuts that secure the contracture footplate to the footplate hinge. 2. Move the contracture footplate to one (1) of four (4) mounting hole. 3. Reinstall the two (2) flat screws, washers and locknuts that secures the contracture foot plate to the footplate hinge. Flat Screws Mounting Hole Contracture Footplate Washers Footplate Hinge Lock Nuts FIGURE 7 - CONTRACTURE FOOTPLATE DEPTH ADJUSTMENT CONTRACTURE FOOTPLATE HEIGHT ADJUSTMENT (FIGURE 8) NOTE: Refer to the GENERAL WARNINGS and INSTALLATION WARNINGS in theSAFETY SUMMARYof this instructionsheet. 1. Remove the mounting screw, two (2) coved washer, washer and locknut that secure the footplate bracket to the contracture support. 2. Move the footplate bracket UP/DOWN to achieve desired height. 3. Align the mounting hole in the footplate bracket with one (1) of seven (7) mounting holes on the contracture support. 4. Secure the footplate bracket to the contracture support with the mounting screw, two (2) coved washers, washer and locknut. Securely tighten. 5. If necessary repeat STEPS 1-4 on remaining contracture footplate. Washers Contracture Support Mounting Holes Mounting Screws Lock Nut Coved Washers Footplate Bracket FIGURE 8 -CONTRACTURE FOOTPLATE HEIGHT ADJUSTMENT REPLACING THE CONTRACTURE FOOTPLATE HEEL LOOP (FIGURE 9) NOTE: Refer to the GENERAL WARNINGS and INSTALLATION WARNINGS in theSAFETY SUMMARYof this instruction sheet. 1. Tilt the contracture footplate forward to gain access to the mounting screws that secure the heel loop to the underside of the contracture foootplate. Refer to angle adjustment of the contracture footplate in this instruction sheet. 2. Remove the four (4) mounting screws and washers that secure the EXISTING heel loop to the contracture footplate. 3. Reverse STEPS 1-2 to install the NEW heel loop. Contracture Footplate Washers Heel Loop Mounting Screws Washers FIGURE 9 - REPLACING THE CONTRACTUREFOOTPLATE HEEL LOOP . . . . '( )*. / . 4 / / . . ! . ,$-. 01 2!. /4 /44 . !"#$"!%&. .. 3 .. 5. /. 6. . 1+7 89 . ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :